DSC STA-CRD - Installation Manual - English - Communique Station Expansion Card

Station Card Instructions Communiqu Station Card is an optional expansion module which increases the number of system stations by eight with the addition of each card Up to two cards can be added to the system for a total of 24 stations the Station Card connect the first station card to the Communiqu Control Unit perform the Fasten the four standoffs provided with the station card to the four screws on the station card area of the control unit Place the station card on top of the standoffs and use the four nuts provided to it into place see Figure 1 below Connect one end of the ribbon cable provided with the station card to the pins on the station card Connect the other end of the ribbon cable to the labelled 8 15 on the control unit located directly above the station see Figure 2 below Ensure that all pins make contact with the connector Line up all pins with the connectors before pushing them into place When connecting a second station card perform steps 2 4 with one exception ribbon cable will be connected to the pins labelled 16 23 on the unit 1 2 WARRANTY Security Controls Ltd warrants that for a period of twelve months from the date of the product shall be free of defect in materials and workmanship under normal use and in fulfilment of any breach of such warranty Digital Security Controls Ltd shall at its option or replace the defective equipment upon return of the equipment to its repair depot This applies only to defects in parts and workmanship and not to damage incurred in or handling or damage due to causes beyond the control of Digital Security Controls such as lightning excessive voltage mechanical shock water damage or damage arising of abuse alteration or improper application of the equipment foregoing warranty shall apply only to the original buyer and is and shall be in lieu of any and other warranties whether expressed or implied and of all other obligations or liabilities on the of Digital Security Controls Ltd This warranty contains the entire warranty Digital Security Ltd neither assumes nor authorizes any other person purporting to act on its behalf to or to change this warranty nor to assume for it any other warranty or liability concerning product no event shall Digital Security Controls Ltd be liable for any direct indirect or consequential loss of anticipated profits loss of time or any other losses incurred by the buyer in with the purchase installation or operation or failure of this product Digital Security Controls Ltd recommends that the entire system be completely on a regular basis However despite frequent testing and due to but not limited to tampering or electrical disruption it is possible for this product to fail to perform as COMPLIANCE STATEMENT Changes or modifications not expressly approved by Digital Security Products Ltd could void authority to use this equipment equipment has been tested and found to comply with the limits for a Class B digital device pursuant Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful in a residential installation This equipment generates uses and can radiate radio frequency and if not installed and used in accordance with the instructions may cause harmful interference to communications However there is no guarantee that interference will not occur in a particular If this equipment does cause harmful interference to radio or television reception which can be by turning the equipment off and on the user is encouraged to try to correct the interference by or more of the following measures Re orient the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio television technician for help user may find the following booklet prepared by the FCC useful to Identify and Resolve Radio Interference Problems This booklet is available from the U S Government Printing Office D C 20402 Stock 004 000 00345 4 Security Products Ltd 160 Washburn St Lockport NY 14094 damage could result to the station card or the control unit if connections are offset You must ensure that proper connections are before applying power to the control unit the Station Card station programming is outlined in the Communiqu Installation and Operation Digital Security Controls Ltd Flint Road Downsview Ontario Canada M3J 2J6 665 8460 1 800 387 3630 in Canada 29002324 R1