DSC ulc installation information 29002157 r005
File Preview
Click below to download for free
Click below to download for free
File Data
Name | dsc-ulc-installation-information-29002157-r005-5493817602.pdf |
---|---|
Type | |
Size | 735.62 KB |
Downloads |
Text Preview
Fire Hour x 12 V 7Ah applicable applicable Note 2 Fire Alarm Hour x 12 V 7 Ah 60 s 120 s minutes Burglary Installation Information Installations Transformer Minimum 16 VAC 37 VA Class 2 CSA cUL Listed Install with ULC Listed devices where applicable standby entry delay exit delay bell cutoff Hour V 4Ah 45 s 60 s minutes Hour x 12 V 7Ah applicable applicable minutes Hour x 12 V 7Ah 60 s 120 s Central Station Central Station standard S310 S540 S302 C693 S302 standard C1023 S545 S304 CAN ULC S527 NFPA 72 CAN ULC S303 communicator for monitoring for monitoring Note 1 Burglary Alarm Control Unit Fire Alarm Control Unit Burglary required LED assembly ULC LA power hardwire tamper Check Local Authority Note 9 See National Building Code Note 9 3.2.4 Resistant Note 10 Notes Note 5 Note 6 Notes 3 4 8 Notes 6 7 Line security requirements 0 Digital communicator enabled and to a single telephone line 1 Digital communicator enabled and to a single telephone line and Listed LINKS 1000 Cellular Transmitter to ULC Listed Sur Gard receiver model SG MLR2 or Listed ADT receiver model UCS 2995001 2995029 to ULC Listed Sur Gard receiver model SG MLR2 or Listed ADT receiver model UCS 2995001 2995029 3 ULC Listed DVACS module P5400 PC4400 P4400 enabled to ULC Listed Sur Gard receiver model SG MLR2 DV or listed ADT receiver model UCS 2995001 2995022 a One wired ULC listed fire module compatible PC5720 P5720 PC5700 P5700 PC4701 P4701 PC4700 or P4700 and 2 independent telephone lines or A telephone line and ULC Listed Links1000 Cellular Alarm Transmitter or One wired ULC Listed DVACS module PC5400 P5400 or PC4400 Each ULC Listed CONTROL UNIT FIRE BURGLARY i e PC5010 MUST be connected to ULC Listed CONTROL UNIT if they are to monitor a complete fire alarm sytem System alarms and troubles to be transmitted The zones comprising the fire alarm system must be programmed to transmit troubles on the communication lines within 4 i e opens ground faults or failure to communicate This applies to all communication configurations dual telephone DVACS or cellular Program zone for ULC Listed 4 wire smoke detectors or compatible ULC Listed 2 wire smoke detectors see diagrams on back Double end of line zone configuration must be used see diagram on back Only one contact per zone This may be connected to ULC Listed Sprinkler Riser devices see diagram on back All system enclosures must be 24 hour tamper protected against opening or removal DSC Tamper Kit T 1 or equivalent This control unit and accessory cabinets initiating devices and bells strobes Keypads must be tampered unless they are the protected area The PC4020 PC4010 and P864 P16128 control units must be in the PC4050CAR cabinet Other control units must use the cabinet DVACS is a registered trademark of Electro Arts Canada notes in the programming sections describing the system configurations for ULC Listed installations must be implemented of the Control Unit Burglary local control and the local power supply must be protected by one of the following ways The control unit and power supply must be within the area of protection which is on a tamper protected circuit Each partition shall arm the area protecting the control unit the audible alarm device power supply This may require protection armed by each partition Access to this area without causing an alarm will require that all be disarmed all cases described above the protected area for the control must be programmed as not by passable and installed in with CAN ULC S302 or CAN ULC S310 Information installer should advise the users and note in the user manual Service organization name and telephone number The programmed exit time The programmed entry time R005