DSC WLS909-433 - Installation Manual - English - 4-button Wireless Key

Replacing WLS909 Key Batteries replace the batteries remove the screw on the back of the and carefully separate the two sides of the key plastic Remove the old batteries from between the two metal Insert the new batteries according to the diagram at left reattach the two sides of the key plastic casing The requires three batteries of type LR44 The polarity of the batteries must be observed COMPLIANCE STATEMENT Changes or modifications not expressly approved by Digital Security Controls Ltd could void your to use this equipment equipment generates and uses radio frequency energy and if not installed and used properly in strict accordance the manufacturer instructions may cause interference to radio and television reception It has been type tested found to comply with the limits for Class B device in accordance with the specifications in Subpart of Part 15 FCC Rules which are designed to provide reasonable protection against such interference in any residential However there is no guarantee that interference will not occur in a particular installation If this does cause interference to television or radio reception which can be determined by turning the equipment and on the user is encouraged to try to correct the interference by one or more of the following measures Re orient the receiving antenna Relocate the alarm control with respect to the receiver Move the alarm control away from the receiver Connect the alarm control into a different outlet so that alarm control and receiver are on different circuits necessary the user should consult the dealer or an experienced radio television technician for additional The user may find the following booklet prepared by the FCC helpful to Identify and Radio Television Interference Problems This booklet is available from the U S Government Print Office Washington D C 20402 Stock 004 000 00345 4 WARRANTY Security Controls Ltd warrants that for a period of twelve months from the date of purchase the product be free of defect in materials and workmanship under normal use and that in fulfilment of any breach of warranty Digital Security Controls Ltd shall at its option repair or replace the defective equipment upon of the equipment to its repair depot This warranty applies only to defects in parts and workmanship and to damage incurred in shipping or handling or damage due to causes beyond the control of Digital Controls Ltd such as lightning excessive voltage mechanical shock water damage or damage out of abuse alteration or improper application of the equipment foregoing warranty shall apply only to the original buyer and is and shall be in lieu of any and all other whether expressed or implied and of all other obligations or liabilities on the part of Digital Security Ltd This warranty contains the entire warranty Digital Security Controls Ltd neither assumes nor any other person purporting to act on its behalf to modify or to change this warranty nor to assume it any other warranty or liability concerning this product no event shall Digital Security Controls Ltd be liable for any direct indirect or consequential damages loss anticipated profits loss of time or any other losses incurred by the buyer in connection with the purchase or operation or failure of this product Digital Security Controls Ltd recommends that the entire system be completely tested on a basis However despite frequent testing and due to but not limited to criminal tampering or disruption it is possible for this product to fail to perform as expected 2000 Digital Security Controls Ltd Toronto Canada Line Canada US 1 800 387 3630 cid 127 www dscgrp com in Canada R003 Key INSTRUCTIONS WLS909 wireless key allows you to arm disarm your alarm system as well as other keypad functions from a unit enough to keep in your pocket Together your installer you can decide which you wish to have accessible from portable key activate any one of the four selected press and hold the appropriate for two seconds Your installer will each function programmed by applying circular label beside each of the four buttons will not be received if the key not within the range of the wireless of the most commonly used functions are as follows this button to arm your system in the Stay mode All perimeter zones will be such as all window and door contacts but the interior zones will remain allowing you to stay on the premises without setting off an alarm Arming Arming this button to arm your system in the Away mode Both the interior exterior zones will be armed allowing you to exit the premises this button to disarm your system You do not have to enter your code when you use the key to disarm the system this button to notify your central monitoring station of a fire condition this button to notify your central monitoring station of a non medical Please discuss the functionality of this button with your installer this button to notify your central monitoring station of a situation the police such as a break in options are available Please discuss all WLS909 options with your in order to program the best possible combination to suit your needs In the UK some restrictions may apply Please contact your for details