DSC WS4917 - Installation Manual - English - Wireless Recessed Door Contact

EV DW4917 Recessed Door Window Installation Manual EV DW4917 is the industries most flexible supervised recessed door window contact a multitude of applications while hiding the transmitter within a door or window frame EV DW4917 uses a replaceable lithium battery and should last 5 years under normal usage the EV DW4917 a flat head screw driver to access the EV DW4917 change tops or access the battery figure 1 Before removing the circuit board that it fits inside a channel on the inside the case When replacing the board ensure fit it back into the same channel for proper fit Board 1 2 Battery care when installing the battery and observe the correct polarity the battery is inserted see Figure 2 Use only Panasonic Lithium batteries for replacement When replacing battery use a flat head driver to open the top See accessing the EV DW4917 Battery may explode if mistreated Do not recharge or dispose of in fire Transmitter and Magnet is important to select the proper placement of the transmitter and magnet The transmitter has two tops that allow a flush mount or screw mount in you accidentally over drill the hole or require extra to ensure the transmitter does not move The does not have a second top with a flange to screw into place so you must be extra careful to ensure that the is tightly in place once installed 1 Install the CR2 battery if you have not already done See Install battery section of the manual 2 Write down the serial number printed on the outside the EV DW4917 case or on the board inside where you the battery 3 Select a location on the door or window frame for EV DW4917 transmitter and magnet to be installed Use a or piece of clay to mark and ensure that the two holes intend to drill are lined up directly across from each other is only one option mounting the You must a the best method based the application 4 Using an 11 16 drill bit slowly drill the first hole for the magnet The EV DW4917 was designed to be slightly larger than an 11 16 hole so you will need to carefully drill to by slowly routing the hole little by little to ensure a snug fit 5 Drill the mating hole for the transmitter and use either the standard flush mount cap and the transmitter for a snug fit or use the flanged cap and use the included screws for the transmitter to the door or window frame If you accidentally drill the magnet side too big and it is loose you can place the transmitter in position and use the flanged cap to screw it into position to your installation manual for enrolling wireless devices into a DSC control panel COMPLIANCE STATEMENT device complies with Part 15 of the FCC Rules Operation is subject to the following two 1 This device may not cause harmful interference and 2 this device must accept interference received including interference that may cause undesired operation The term before the radio certification number signifies that Industry Canada technical specifications were met Secure Wireless Support 866 908 TECH 8324