Edwards 102 Mounting Flange Instructions

Installation Instructions for Mounting Flange Kit use with the 102 Series TrilipticalTM Stackable Status Indicator Panel mount the 102PMF pipe mount flange A as follows Using the supplied gasket D as a guide mark the four holes and the center clearance hole on an surface Punch the four mounting holes Punch the wiring hole in the mounting surface to be sufficiently than that in the gasket to ensure the wiring is protected from abrasion by the gasket interfering with the mounting screw holes or other appropriate wire insulation abrasion as needed Screw the pipe extension purchased separately into the flange Ground the flange by pulling the ground wire through mounting surface clearance hole and center hole of gasket Connect earth ground to the bottom of the mount flange using the ground screw G and wire terminal cup washer H Pull the remaining field wiring through center clearance of mounting surface center hole of the gasket pipe flange and extension pipe Align the mounting gasket D and flange A on the Secure using 4 10 24 x 1 25 mm pan head B 4 external tooth 10 star washers E and 10 24 hex nuts F See Figure 1 Mount the base as follows either Cat No 102TBS or Cat No 102PMBS on 3 4 19 mm conduit not supplied Pull field through conduit entrance hole Connect field wiring as instructed in the installation P N 500002 provided with themounting base Assemble the stackable beacon lighting system as described the installation instructions provided with either the base or the appropriate components 1 102PMF pipe mount flange 4 10 24 x 1 25 mm pan head phillips screws 4 o rings 1 mounting gasket 4 external tooth 10 star washers 1 green 10 16 x 3 8 pan head thread forming ground 10 24 hex nuts 1 brass terminal cup washer Extension Pipe Extension Pipe Extension Pipe Edwards Triliptical Stackable Beacon Lighting System is a audible visual signaling device that can contain up to 5 modules and either a single or multiple tone module in a stack pipe mount flange 102PMF and one of the three extension sold separately allow the status indicator to be raised above mounting surface for increased visibility It can be used with the Cat No 102TBS or Cat No 102PMBS mounting bases must be in accordance with the latest edition of the Electrical Code and other governing standards and codes standard installation prevent electrical shock do not connect power instructed to do so prevent abrasion of wiring insulation ensure wire passage holes are adequately protected CT 203 699 3000 FAX 860 677 7746 500034 ISSUE 2 1998 o rings 10 24 x 1 25 mm head screws No 102PMF mount flange retention cup washer x 3 8 head thread forming screw tooth Star washer gasket Hex nut 500034 ISSUE 2 1 Mounting Kit Assembly