Edwards 103 Series Installation Instructions

Installation Instructions for ChameleonTM 103 Series Multi Status Indicator in NEMA 4X Enclosures 103 Series Chameleon Multi Status LED Indicator is a UL cUL listed multi color LED signaling appliance in a NEMA and IP65 rated enclosure The modules can be panel mounted conduit mounted lights are available in 24V DC and 120V 50 60 Hz They are in either red blue and amber or red green and amber lights are designed such that any one or all three lights can be using a PLC prevent electrical shock ensure that power is turned before installing the signal Mounting Figure 1 Thread the 18 45.7 cm signal wire leads through either 13mm or 3 4 19 mm conduit into an approved outlet box Product is supplied with a double 1 2 13mm internal and 3 4 19mm external hub Wire the beacon as follows For AC models There are four 18 wire leads white red for activation of red LEDs white with green for activation of green or blue LEDs depending model and amber for activation of amber LEDs wire nuts connect white lead to AC neutral and each of the other three leads to AC hot For DC models There are four 18 wire leads black red for activation of red LEDs white with stripe for activation of green or blue LEDs on model and amber for activation of amber wire nuts connect black lead to DC common and each of the other three leads to DC hot Thread the conduit onto the base of the signal Turn on power and verify that the signal operates properly Switching Mounting Figure 2 The integrity of the outdoor NEMA 4X rating on the panel at the interface with the 103 Series Chameleon relies the construction and configuration details of the mounting Installer should evaluate Place the mounting gasket supplied over the hole in the and route the signal wires through the gasket and the in the panel the base through the hole in the panel and screw the nut supplied with the raised locking edge facing mounting surface onto the base to secure the beacon Wire the beacon as follows For AC models There are four 18 wire leads white red for activation of red LEDs white with green for activation of green or blue LEDs depending model and amber for activation of amber LEDs wire nuts connect white lead to AC neutral and each of the other three leads to AC hot For DC models There are four 18 wire leads black red for activation of red LEDs white with stripe for activation of green or blue LEDs on model and amber for activation of amber wire nuts connect black lead to DC common and each of the other three leads to DC hot Turn on power and verify that the signal operates properly avoid the risk of injury do not start any maintenance unit is energized Reinstall lens beore energizing module lens exterior surfaces should be periodically cleaned a soft clean cloth using water and a mild detergent to main optimum light visibility Disconnect power before cleaning Replacement prevent electrical shock disconnect power before the lens Remove 4 screws securing the lens to the base from bottom base and remove lens Replace lens on base and secure with 4 screws removed in 1 CT 203 699 3300 FAX 203 699 3365 CUST SERV 203 699 3078 TECH SERV 3100414 ISSUE 1 2001 1 PLC Compatibility voltage off state current current No AC volts at 60 Hz DC AC Amps milliseconds Series Chameleon Status Indicator 19 mm NPT not supplied DC common or White AC neutral DC hot or AC hot Red LED activation DC hot or AC hot Amber LED activation Nuts supplied source wires Series Chameleon Status Indicator or White with Green DC hot or AC hot Blue or Green LED activation on model DC hot or AC hot Red LED activation DC hot or AC hot Amber LED activation 1 Conduit Mounting 3 4 Shown or White with Green tracer hot or AC hot Blue or Green LED activation on model Nut OD panel nuts supplied DC common or AC neutral 3100414 ISSUE 1 2 Panel Mounting