Edwards 117 Series Installation Instructions

Series Strobe Installation Sheet Edwards 117 Series Strobe is a low profile surface UL and cUL listed signaling appliances in a NEMA 4X enclosure no VDC VAC VAC tube To prevent electrical shock ensure power is off before installation or maintenance Letter in this position indicates lens color A amber B blue C G green or R red surface mount the strobe Place the mounting gasket supplied over the hole in the and route the signal wires through the gasket and hole in the panel Secure the beacon to the surface using two screws for the mounting surface not supplied Using wire nuts not supplied connect the signal s wire as shown in Figure 1 Polarity must be observed on units 1 Mounting module lens exterior surfaces should be periodically with a soft clean cloth using water and a mild to maintain optimum light visibility Disconnect power cleaning source replacement Disconnect wiring Unscrew lens from base Unplug strobe tube and replace with new strobe tube as see specifications Replace lens on base 2013 UTC Fire Security All rights reserved 2 3100818 REV 02 REB 25FEB13