Edwards 125 Class Standard LED Instructions

Installation Instructions for 125 Class Beacons LED Models Thread the conduit onto the base of the signal Turn on power and verify that the signal operates Mounting Figure 2 avoid risk of injury install lens before the unit avoid the risk of injury do not remove or lamp when unit is energized When panel mounting the beacon the surface and details of the panel must be taken into in order to ensure that the integrity the outdoor NEMA 4X rating is fully maintained should evaluate Place the mounting gasket supplied over the hole in panel and route the signal wires through the gasket the hole in the panel the base through the hole in the panel and screw locking nut supplied with the raised locking edge the mounting surface onto the base to secure the Wire the beacon as follows For AC models use wire nuts not supplied and the signal black and white wire leads to the source wires as shown in Figure 2 Polarity not relevant For DC models connect the signal red wire to the power source wire and connect the signal wire to the negative power source wire using nuts not supplied Polarity must be observed to Figure 2 Turn on power and verify that the signal operates 125 Class LED Beacons are UL and cUL listed appliances rated for NEMA 4X applications Two of 125 Class Standard LED Beacons are available 65 FPM 125LEDF and Steady On 125LEDS versions can be either surface or conduit mounted protective wire guard Cat No 125GRD is available Specifications BASE Number BASE Number LED LED in this position indicates lens LED color Amber B Blue G Green R Red DC AC 50 60 Hz DC AC 50 60 Hz Specifications Locations Ratings 31F to 150F 35C to 66C prevent electrical shock ensure that is turned off before installing the Mounting Figure 1 Thread the 18 457 mm signal wire leads through either or 3 4 conduit into an approved conduit outlet box is supplied with a double threaded 1 2 internal 3 4 external conduit hub Wire the beacon as follows For AC models use wire nuts not supplied and the signal black and white wire leads to power source wires as shown in Figure 1 For DC models connect the signal red wire to the power source wire and connect the signal wire to the negative power source wire using nuts not supplied Polarity must be observed to Figure 1 Phone 800 336 4206 Fax 800 454 2363 3101756 ISSUE 3 2010 avoid risk of injury install lens before the unit avoid the risk of injury do not start any when unit is energized power before cleaning The module lens exterior should be periodically cleaned with a soft clean cloth water and a mild detergent to maintain optimum light 1 Conduit Mounting 3 4 Shown 2 Panel Mounting Nut OD panel Class Indicator NPT external shown NPT internal not supplied Wire Leads units Red positive units Black Hot units Black negative units White neutral nuts supplied Source Class Indicator Wire Leads Nuts Supplied Source 1 Replacement Parts BASE BASE Lamp Number Number LED LED in this position indicates lens color A Amber B Blue G Green R Red on LED manufacturer projections 100,000 hour LED light is permanently installed 100,000 hour LED light is permanently installed