Edwards 125 Class Strobe Installation Instructions

Installation Instructions for 125 Class Beacons Models 125 Class Strobes are UL and cUL listed signaling rated for NEMA 4X applications There are two of strobes available Normal Light Output and High Output Both types can be either surface or conduit A protective wire guard Cat No 125GRD is also Specifications BASE BASE Number Catalog Number Output Strobe 300,000 Peak Candlepower capacitor operating temperature Tc is 185 85 Output Strobe 175,000 Peak Candlepower in this position designates lens color amber B blue C clear G green or R red AC 50 60 Hz AC 50 60 Hz AC 50 60 Hz 48V DC Specifications Locations Ratings 31F to 150F 35C to 66C prevent electrical shock ensure that is turned off before installing the Mounting Figure 1 Thread the 12 45.7 cm signal wire leads through 1 2 conduit into an approved conduit outlet box Thread the conduit onto the base of the signal Using wire nuts not supplied connect the signal wire as shown in Figure 1 Polarity must be observed DC models For AC models polarity is not important Mounting Figure 2 When Place the mounting gasket supplied over the hole in panel and route the signal wires through the gasket the hole in the panel the base through the hole in the panel and screw locking nut supplied with the raised locking edge the mounting surface onto the base to secure the Using wire nuts not supplied connect the signal wire as shown in Figure 2 Polarity must be observed prevent electrical shock ensure is turned off before installation or avoid risk of injury install lens before maintain optimum light visibility the exterior lens surfaces be periodically cleaned with a soft clean cloth us water and a mild detergent Disconnect power before Tube Replacement Conduit Mounted Modules Disconnect wiring and if unscrew base from conduit Figure 1 Mounted Modules Disconnect wiring and locking nut that secures the base to the panel 2 Remove screws that secure the lens to the base from of base and remove lens Do not touch strobe tube while hot Phone 800 336 4206 Fax 800 454 2363 3101651 ISSUE 3 2010 Nut OD panel Class Indicator NPT external shown NPT internal not supplied Wire Leads units Red positive units Black Hot units Black negative units White neutral nuts supplied leads to Source 1 Conduit Mounting 3 4 Shown Class Indicator Wire Leads Nuts Supplied Source 2 Panel Mounting Tube strobe tube Shown Socket in groove Screws securiing to base 3 Strobe Tube Replacement 1 Replacement Parts BASE BASE Number Number Strobe Tube Output Strobe Output Strobe in this position indicates lens color A Amber B Blue C Clear G Green R Red 3101651 ISSUE 3