Edwards 2325 2327 Installation Instruction

Sentrol Series Panel Magnetic Contact Instructions 2300 Series is designed for use with sectional panel doors that use metal roller tracks The contact roller tracks up to 3 inches wide a Location the following guidelines to select a location for the Mount the switch high enough so the cable is off the If other track mounted devices interfere mount switch under them Locate the magnet away from handles and latches to it from being used as a foothold or a handle to the door the Contact Run the security system wiring to the switch location Align the magnet with the switch and attach it to the with the two screws provided as follows magnet must be 1 4 to 1 2 inch away from the switch See Figure 3 magnet can be attached at two different elevations from the door See Figure 3 Place the switch over the door track See Figure 1 Slide the beveled edge of the L bracket into the slot of switch until it snaps firmly in place Tighten the on the switch down firmly 2 Attaching Magnet to Door View track 1 Mounting the Switch 1 2 spacing 3 Magnet Mounting Options Connect the switch wires to the security system wiring verify the switch works properly make distance 7.5 cm max distance approx 1.1 to 1.5 times make distance type 2 0.61 m stainless steel armored cable housing extruded aluminum temperature 40 cid 176 to 150 cid 176 F 40 cid 176 to 65 cid 176 C dimensions 8.26 cm 3.75 9.53 cm 6.93 cm dimensions 8.92 cm 4.32 cm 7.87 cm 634 pending Specifications Ordering Rev A 11 99