Edwards 3000SD-EK Installation Instructions

cid 1 cid 2 cid 3 cid 4 cid 5 cid 6 cid 6 cid 5 cid 4 cid 7 cid 8 cid 2 cid 9 cid 1 cid 2 cid 3 cid 4 cid 10 cid 11 cid 12 cid 4 cid 7 cid 8 cid 2 cid 3 cid 9 cid 13 cid 8 cid 10 cid 9 cid 14 cid 5 cid 4 cid 15 cid 9 cid 16 cid 17 cid 17 cid 17 cid 18 cid 19 cid 9 cid 18 cid 20 cid 10 cid 7 cid 20 cid 3 cid 1 cid 2 cid 22 cid 11 cid 3 cid 4 cid 10 cid 7 cid 5 cid 6 cid 9 cid 25 cid 10 cid 11 cid 12 cid 26 cid 9 cid 27 cid 7 cid 28 cid 29 cid 4 1 2 mm 1 2 mm mm 1 Dimensions 3000SD Series visual signals are flange mount strobes for industrial applications and for applications warning on a moving vehicle is necessary The light 80 nominal single flashes per minute at 1.5 Joules It a low current 12 48V DC unit The twist on off lens for easy strobe tube and or lens replacement prevent electrical shock do not connect power instructed to do so must be in accordance with local codes The should be positioned up for outdoor applications For side exit wiring remove the knockout from the of the flange as shown in Figure 2 Using the template provided Figure 3 drill 3 holes and a hole for concealed wiring if Connect the red positive lead to the positive power wire and the black negative lead to the power source wire using the butt splices Align the provided gasket and the flange on the holes and secure using 3 screws and nuts supplied Apply power and verify operability lens should be periodically cleaned using a mild de and water on a soft clean lint free cloth Source Replacement prevent electrical shock disconnect power and 5 minutes for the strobe tube energy to dissipate opening the unit Unscrew the lens from the base Replace the strobe tube as follows Grasp the strobe tube by its base and pull straight out of the strobe tube socket Grasp the new strobe tube by the strobe tube base press into the strobe tube socket Confirm O ring gasket is seated and aligned properly the inside of the lens Screw the lens onto the base 1 Electrical Specifications Current A Current A A mS Current Current Surge Current mS A DC DC DC the operating current to establish the wire gauge and standby power requirements Consult the control unit manufacturer to surge and peak current effects and maximum number of strobes on the system for exit wiring Mounting 2 Beacon Base CT 203 699 3300 FAX 203 699 3365 CUST SERV 203 699 3078 TECH SERV 3100383 ISSUE 1 2001 Mounting Holes 9.5 mm hole concealed wiring is 3 Mounting Template 2 Replacement Parts Tube 3100383 ISSUE 1