Edwards 6536-G5 Installation Instructions

Installation Instructions for the Horn Strobe 6536 G5 is an audible visual signal UL Listed for general signaling applications qualified electrician familiar with National Electrical Code local code requirements must install this product Failure to the safety precautions in this instruction sheet could result product or property damage severe personal injury or death reduce the risk of shock do not remove lens or with unit when the circuit is energized Do connect AC power until installation is complete 6536 G5 horn strobe Figure 1 can be mounted on any single 2 x 4 51 mm x 102 mm electrical box double gang 4 x 4 mm x 102 mm electrical box or standard 4 x 4 102 mm x mm junction box with a plaster ring an appropriate electrical box using suitable hardware Connect the horn strobe wire leads and terminals Figure 2 horn and strobe are connected together at the factory To connect the horn and strobe to different circuits the terminals remove the two wires and cap off wire nuts Mount the horn strobe onto the electrical box Secure it using screws supplied Perform an operational test reduce the risk of shock do not remove lens or with unit when the circuit is energized power and allow five 5 minutes for energy to dissipate before starting work or High energy could be stored in the circuit once it is energized regularly scheduled testing at least twice a year or more as dictated by local authorities having jurisdiction 1 Specifications Voltage Current 50 60 Hz mA DC mA 9 16 mm 1 2 mm separate 24V AC 24V DC power source installed 1 Details of Horn Strobe Box 24V AC or DC Power Source 2 Connecting the Horn and Strobe CT 203 699 3300 FAX 860 677 7746 ISSUE 1 1999