Edwards B-KBH-5040-N5 Installation Instructions

Installation Instructions for Catalog No Phone Bell these devices damage the telephone network the telephone will notify the owner that it may temporarily discon service if they consider such action necessary If the owner the disconnection unwarranted they have the right to a complaint to the FCC telephone company may make changes in its communica facilities equipment operations or procedures when such is required If these changes render the devices incom with the telephone company facilities the telephone com will provide enough written notice so that necessary can be made in order to maintain uninterrupted ser SPECIFICATIONS AC Hz DC Switching Amps AC DC Desc No Remote Phone Mount the phone bell to a flat surface using three mounting not provided Remove the four 8 x 5 8 16mm pan head Phillips screws remove the phone bell cover Wire the phone bell as shown in Figure 2 Replace the phone bell cover and secure with the screws Test the phone bell by dialing the appropriate number or in Step 2 1 Phone Bell Dimensions Edwards B KBH 5040 N5 Phone Bell is a solid state unit powered by 120V 60 Hz The unit is acti by AC or DC voltage through solid state relays The bell is designed for use in indoor areas that have me ambient noise level such as warehouses and garages unit is rated at 104 dB at 10 feet 3.05m The phone bell UL listed and comes with strain relief connectors which the 6 foot 1.83m power cord to the housing These devices are intended for connection to single line tele or key systems only They are not intended for use party line or on coin telephone lines When installed in accordance with these instructions the can be readily disconnected without affecting remaining on the telephone network Registered with the Federal Communications Commission compliance with Part 68 of FCC Rules and Regulations REN allows the installer to determine the number of de that can be added to the telephone line and still have all devices ring when the number is called In most but not areas the sum of all RENs for all devices connected to line should not exceed five To be sure of the number of you can connect to your telephone line contact your telephone company TELEPHONE INFORMATION unit is not serviceable or repairable Should the fail to operate contact the supplier for replacement following information may be required by the telephone Telephone Number FCC Registration Number Ringer Equivalence Number REN at greater than 50 Volts and 3.4B at less than 50 Volts this product should fail to operate disconnect it from the tele line and determine if the problem is in the telephone line the device If this product is defective discontinue its use obtain a replacement CT 203 699 3000 FAX 203 699 3075 ISSUE 1 1996 2 Electrical Connections ISSUE 1