Edwards B-KH Series Installation Instructions

Installation Instructions for B KH Series Phone Signal line should not exceed five To be sure of the number of you can connect to your telephone line contact your telephone company these devices damage the telephone network the telephone will notify the owner that it may temporarily discon service if they consider such action necessary If the owner the disconnection unwarranted they have the right bring a complaint to the FCC telephone company may make changes in its communica facilities equipment operations or procedures when such is required If these changes render the devices incom with the telephone company facilities the telephone will provide enough written notice so that necessary can be made in order to maintain uninterrupted ser Edwards B KH Series Line Powered Remote Phone Sig Figure 1 are available in three models strobe horn Cat B KHE 1000 PP strobe Cat No B KHD 1000 PP or Cat No B KHS 1000 PP When equipped with a a xenon strobe lamp is used for increased light output horn when used is a piezo horn with manual adjustment sound output Combination units are designed for wide coverage in noisy locations Strobe only units are ideal use in quiet areas such as libraries broadcast studios hos and offices All units are for interior use only remote phone signal responds to any ring signal within frequency range of 16 70 Hz and voltage range of 85 115 RMS The units require no external power and connect to your phone system These devices are intended for connection to single line or key systems only They are not intended for on party line or on coin telephone lines When installed in accordance with these instructions the can be readily disconnected without affecting remaining on the telephone network Registered with the Federal Communications Commission compliance with Part 68 of FCC Rules and Regulations TELEPHONE INFORMATION following information may be required by the telephone Telephone Number FCC Registration Number Ringer Equivalence Number REN REN allows the installer to determine the number of de that can be added to the telephone line and still have all devices ring when the number is called In most but not areas the sum of all RENs for all devices connected to 1 Phone Signal Dimensions SPECIFICATIONS No AC the phone line voltage drops below 85V the strobe may to function CT 203 699 3000 FAX 203 699 3075 ISSUE 1 1996 Telecommunication wiring which is connected to the series signal shall not extend outside the building the signal is contained in Mount on any solid surface using the spacing template Figure 2 Connect one end of standard modular telephone line to tee and the other end to the phone signal unit Connect a standard modular telephone line from the tee jack to telephone See Figure 3 Adjust volume of horn using the manual shutter The shutter the horn provides variable attenuation up to 20 dB Verify operability of unit In the event of malfunction from phone to prevent possible damage to phone unit is not serviceable or repairable Should the unit to operate contact the supplier for replacement this product should fail to operate disconnect it from the tele line and determine if the problem is in the telephone line or device If this product is defective discontinue its use and a replacement 2 Spacing Template ISSUE 1 2 Mounting the Remote Phone Signal