Faraday RDC-2 REMOTE LCD ANNUNCIATOR

INSTALLATION INSTRUCTIONS AND WIRING FOR NO RDC 2 REMOTE LCD ANNUNCIATOR RDC 2 Remote LCD Annunciator is an optional accessory for the MPC 6000 and MPC 7000 Fire System Control Unit The RDC 2 provides a 80 character LCD display along with the system status The enable keyswitch allows system reset trouble silence acknowledge alarm silence and menu The lamp test operation is also enabled by the keyswitch but the function is limited to the The annunciator mounts to a horizontally mounted 6 gang box 2 deep minimum The 12411 Surface Backbox may be used for surface mounting SUPPLIED is to be done by qualified personnel have thoroughly read and understood this sheet LCD Annunciator Screws Sheet Instructions 2 Disconnect BATTERY and AC prior to working on 3 Mount 6 gang backbox horizontally as required 1 DIMENSIONS mounting below 4 Set dip switch for proper remote address 1 16 5 Attach conduit and run wires as required 6 Connect IN wires from fire alarm system control or previous remote as required 7 Connect OUT wires to next remote or 120 ohm resistor P N 140 820350 8 Attach unit to backbox using four P N 906 220608 9 Apply power to system 10 Check for proper operation of functions DIMENSIONS WIRING Limited and Supervised for power and pair Cable for data X X from panel or previous and to next remote or ohm termination resistor 140 820350 on the last to be installed in accordance with all local is not allowed Communication wiring be daisy chained from remote to remote block will accept a maximum of 12 AWG and minimum of 18 AWG twisted pair cable with a characteristic of approximately 120 ohms 4000 feet distance from panel to last remote Fernwood Road Park New Jersey 07932 315 049103FA 3 1 OF 2 following table shows the dip switch settings for proper addressing of the RDC 2 remotes Switch 1 Switch 2 Switch 3 Switch 4 ON following table gives the currents necessary for power supply and battery calculations Voltage Current V DC A A 315 049103FA 3 2 OF 2