Farenhyt IDP-Fire-CO Combination Fire and CO Detector

Advanced Multi Criteria Fire CO Detector IDP FIRE CO is a plug in addressable device that both fire and carbon monoxide CO detection For the detector combines four separate sensing elements in unit smoke CO light flame and heat to sense multiple of a fire This approach enables enhanced to real fire with heightened immunity to nuisance For CO the detector electrochemical sensing creates a separate signal for life safety CO detection through the incomplete burning of various fuels is a colorless odorless and deadly gas that is virtually to detect with the human senses Because the exists for dangerous levels of CO to accumulate in any building legislation mandating the use of CO in commercial spaces continues to increase across U S and Canada The IDP FIRE CO is listed to the UL standard for system connected life safety carbon monitoring IDP FIRE CO should be used in conjunction with the intelligent sounder base sold separately can generate either a Temp 3 pattern for fire or a Temp pattern for CO alarm indication With each sounder base a unique address the FACP can then command an sounder or a group of sounders to activate The set from the panel can be tailored to the specific allowing selection of tone and group For more on the B200S B200S LF refer to Data Sheet P N can also be used with the B210LP 6 standard the B200SR sounder base or the B224RB relay base Unique ability to detect all four major elements of a fire Smoke Carbon Monoxide CO Light flame Heat Separate CO detection signal Highest nuisance alarm immunity Automatic drift compensation of smoke sensor and CO cell Uses only one address on the SLC RealTest CO testing capability UL 268 and UL 2075 listed Separates audible signal for fire or CO alarm when used B200S B200S LF base CO cell end of life warning and fault Listings in a B200S B200S LF Base sold separately IDP FIRE CO is compatible with the FACPs programmed for System protocol Firmware version 13.0 or for IFP 100 IFP 1000 Firmware 4.0 or higher for IFP 2000 IFP 2000 RPS 2000 Intelligent Fire Panel IFP 2000ECS Emergency Communication with Fire Alarm Control Pane IFP 1000 Intelligent Fire Panel IFP 1000ECS Emergency Communication with Fire Alarm Control Panel IFP 100 Intelligent Fire Panel IFP 100ECS Emergency Communication with Fire Alarm Control Panel IFP 50 Intelligent Fire 351180 Rev F 2015 Honeywell International Inc Weight Range 17.46 cm installed in a base 8.79 cm installed in base oz F to 100 F 0 C to 38 C to 90 relative humidity to 4,000 ft min 0 to 20 m sec Velocity Voltage 15 to 32 VDC Standby and Alarm Current 300 Settings settings are programmable through zone per foot 30.48 cm of Used in equipment kitchens paint shop per foot 30.48 cm of Moderately clean Used in hotel dorm rooms per foot 30.48 cm of Clean environments in offices After the CO cell has reached the end of life CO sensor no longer provides life safety protection when the fire detector enters Photo Thermal PTIR mode the following sensitivities apply 1 per foot 30.48 cm of smoke clean environments Used in per foot 30.48 cm of smoke environments offices per foot 30.48 cm of smoke clean environments in hotel rooms dorm rooms alarm at 135 F 57 C 2 5 6 Monitoring UL Standard Reference Alarm are as follows Response Time Per Million 5 ppm 5 ppm 10 ppm min min min Per UL Standard 2075 the IDP FIRE CO has tested to the sensitivity limits defined in UL 2034 Information Multi Criteria CO Detector base not Due to the unique nature of this detector please consult Fire Alarm Control Panel Manufacturer for the specific and compatibility Accessories sounder base Frequency Intelligent sounder base mounting base base base test magnet test magnet document is not intended to be used for installation purposes We try to keep our product information and accurate We cannot cover all specific applications or anticipate all requirements All are subject to change without notice For more information contact Silent Knight 12 Clintonville Northford CT 06472 1610 Phone 800 328 0103 Fax 203 484 7118 Technical Support Please call 800 446 6444 www farenhyt com