Farenhyt IDP-Iso Fault Isolator Module

Line Isolator Module IDP ISO is a SLC loop line isolator module for use with Knight IFP series fire alarm control panels FACPs The acts as an automatic switch that opens when the line on the signaling line circuit SLC loop drops below four Isolator modules should be spaced between groups of or modules in a loop to protect the rest of the loop If a occurs between any two isolators then both isolators switch to an open circuit state and isolate the between them The remaining units on the SLC loop to fully operate No more than 25 devices are for each group Isolates short circuits on an SLC loop Protects the modules on the SLC loop so other devices to operate is solid red in alarm Panel controlled status LED that flashes green in normal state Standard 4 inch electrical box mounting SEMS screws for easy wiring UL Listed IDP ISO mounts directly into a 4 square electrical box The must have a minimum depth of 2 1 8 A surface mount box System Sensor PN SMB500 is available from Knight Listings Vol X IDP ISO is compatible with the FACPs IFP 2000 RPS 2000 Intelligent Fire IFP 2000ECS Emergency System with Fire Panel IFP 1000 ECS Intelligent Fire Panel IFP 100 ECS Intelligent Fire Panel IFP 50 Intelligent Fire IFP 25 Intelligent Fire 350287 Rev H 2015 Honeywell International Inc Information Isolator Module Square Surface Mount Electrical Box 4.5 11.4 cm 4 10.2 cm 0.25 0.6 cm Weight 6.3 oz 196 g Voltage 15 32 VDC Current 450 max not isolating relay closed Current 17 mA Line Loop Resistance 40W Temperature 32 120 0 49 10 93 non condensing document is not intended to be used for installation purposes We try to keep our product information and accurate We cannot cover all specific applications or anticipate all requirements All are subject to change without notice For more information contact Silent Knight 12 Road Northford CT 06472 1610 Phone 800 328 0103 Fax 203 484 7118 Technical Support Please call 800 446 6444 www farenhyt com