Farenhyt SpectrAlert® Advance Selectable Output Notification Appliances General

The SpectrAlert Advance Output Appliances Sensor SpectrAlert Advance selectable output strobes and horn strobes are rich with features to cut installation times and maximize profits The Advance series of notification appliances is designed simplify your installations with features such as plug in instant feedback messages to ensure correct installation individual devices and eleven field selectable candela settings wall and ceiling strobes and horn strobes specifically when installing Advance products first attach universal mounting plate to a four inch square four inch or double gang junction box The two wire mounting attaches to a single gang junction box connect the notification appliance circuit wiring to the terminals on the mounting plate attach the horn strobe or horn strobe to the mounting by inserting the product tabs in the mounting plate The device will rotate into position locking the product into the mounting plate terminals The device will hold in place with a catch until it is secured with a mounting screw Plug in design Universal mounting plate for wall and ceiling units Shorting spring on mounting plate for continuity check before Rotary switch for horn tone and three volume settings Tamper resistance construction Field selectable candela settings on wall and ceiling units 15 75 30 75 95 110 115 135 150 177 and 185 Automatic selection of 12 or 24 volt operation at 15 and 15 75 Outdoor wall and ceiling products Devices Listings Ceiling Ceiling Wall Wall Strobe Wall Outdoor products rated from and and 66 Three volume selections and rotary switch horn tone Horn rated at 88 dbA at 16 volts Electrically compatible with existing products available Indoor wall mount horn strobe 2 wire 4 wire horn strobe Indoor ceiling mount strobe 2 wire 4 wire horn strobe Outdoor wall mount horn strobe 2 wire 4 wire horn strobe Outdoor ceiling mount strobe 2 wire 4 wire horn strobe 350377 Rev A 2010 Honeywell International Inc Specifications Advance horns strobes and horn strobes shall mount to standard 4.0 x 4.0 x 1.5 10.16 x 10.16 x 3.81 cm backbox 10.16 cm octagonal backbox or a double gang backbox Two products shall also mount to a single gang 2.0 x 4.0 x 1.875 x 10.16 x 4.763 cm backbox A universal mounting plate shall used for mounting ceiling and wall products The notification circuit wiring shall terminate at the universal mounting Also SpectrAlert Advance products when used with the Module accessory shall be powered from a non notification appliance circuit output and shall operate on a 12 or 24 volts When used with the Sync Module rated notification appliance circuit outputs shall operate 9 and 17.5 volts 24 volt rated notification appliance circuit shall operate between 17 and 33 volts Indoor SpectrAlert products shall operate between 32 and 120 0 and from a regulated DC or full wave rectified unfiltered power Strobes and horn strobes shall have field selectable candela including 15 15 75 30 75 95 110 115 135 150 strobe shall be a System Sensor SpectrAlert Advance Model listed to UL 1971 and shall be approved for fire protective The strobe shall be wired as a primary signaling notification and comply with the Americans with Disabilities Act for visible signaling appliances flashing at 1 Hz over strobe entire operating voltage range The strobe light shall of a xenon flash tube and associated lens reflector system COMBINATION horn strobe shall be a System Sensor SpectrAlert Advance listed to UL 1971 and UL 464 and shall be approved fire protective service The horn strobe shall be wired as a notification appliance and comply with the with Disabilities Act requirements for visible signaling flashing at 1 Hz over the strobe entire operating range The strobe light shall consist of a xenon flash tube associated lens reflector system The horn shall have three options and an option to switch between a Temporal 3 and a Non Temporal continuous pattern These options are by a multiple position switch On four wire products the strobe be powered independently of the sounder The horn on models shall operate on a coded or non coded power PRODUCTS Advance outdoor horns strobes and horn strobes shall listed for outdoor use by UL and shall operate between 151 and 66 The products shall be listed for use a System Sensor outdoor weatherproof backbox with half inch three fourths inch conduit entries MODULE module shall be a System Sensor Sync MDL3RA or listed to UL 464 and shall be approved for fire protective The module shall synchronize SpectrAlert strobes at 1 Hz horns at Temporal 3 Also while operating the strobes the shall silence the horns on horn strobe models over a single of wires The module shall mount to a 4.688 x 4.688 x 2.125 x 11.906 x 5.398 cm backbox The module shall also two Style Y class B circuits or one Style Z Class A circuit module shall synchronize multiple zones Daisy chaining two or synchronization modules together will synchronize all the they control The module shall not operate on a coded power Standard operating temperature 32 to 120 K Series operating temperature to 151 Humidity range 10 to 93 non condensing to 49 to 66 products Strobe flash rate 1 flash per second Nominal voltage regulated 12 VDC FWR or 24 VDC FWR NOTE Full Wave FWR voltage is a non regulated time power source that is used on some power and panel outputs Operating voltage range 8 V to 17.5 V 12 V or 16 V to 33 V 24 V nominal P S PC and SC products will operate at V nominal only for 15 cd and 15 75 cd Input terminal wire gauge 12 to 18 AWG 3.31 to mm Ceiling mount dimensions including lens 6.8 x 2.5 deep 17.3 cm diameter x 6.4 cm Wall mount dimensions including lens 5.6 H x W x 2.5 D 14.2 cm H x 11.9 cm W 6.4 cm D Horn dimensions 5.6 H x 4.7 W x 1.3 D 14.2 cm x 11.9 cm W x 3.3 cm D Current Draw Maximum mA RMS V V 142 NA NA NA NA NA NA DC FWR 158 181 202 210 228 246 281 286 Current Draw Maximum mA RMS 17.5 V 33 V FWR DC FWR Medium 44 High Medium 42 44 and Horn Strobe Switch Setting Repetition Rate Level horn horn horn horn horn horn coded High coded Medium coded Settings 7 8 and 9 are not on 2 wire horn strobe and Horn Strobe Output dBA 17.5 V 33 V FWR DC FWR Medium Settings 7 8 and 9 are not available on 2 wire horn strobe Horn Strobe Standard Candela Range 15 115 cd Maximum Current Draw mA RMS Sound Pattern dB Level Input Temporal High Input Temporal Medium Inpu