Fike Conventional Smoke Detector Bases P 1 20 01

CONVENTIONAL SMOKE BASES and Engineer Specification AND 6 SERIES SMOKE DETECTOR BASE 67 1034 67 1035 67 1036 67 1037 Listed S4021 Approval 3010873 4 and 6 Series Smoke Detector Bases are designed for use with the 67 1033 Ionization Smoke 63 1024 Photoelectric Smoke Detector 63 1025 with Heat Smoke Detector and the 60 1029 60 1030 Fixed Temperature Rate of Rise Heat Detector 6 base is an electronics free base featuring a plastic lug Each base is equipped with a resistor Refer the chart below for additional specifications The 4 base a 4 version of the 6 base 63 1012 is designed specifically for use with the 67 Ionization Smoke Detector 63 1024 Photoelectric Detector 63 1025 Photoelectric with Heat Smoke or the 60 1029 or 60 1030 Fixed Temperature Heat Detector The 63 1012 is a 6 base with sets of Form C relay contacts DPDT 1 amp at 30 and 0.5 amp at 125 VAC when this type of function is It is Underwriters Laboratories approved for device service 63 1012 is also approved for use with Fike Models 67 1016 63 1007 63 1016 60 1020 60 1022 2003 Issue WIRE AUXILLIARY RELAY BASES Current 43mA 58mA 30.0V Max S 10th Street P O Box 610 cid 127 Blue Springs Missouri 64013 0610 U S A cid 127 816 229 3405 cid 127 Fax 816 229 0314 cid 127 www fike com Base Series Base Series of Line Device 1 2W Listed shown is example only Not annunciators have line resistance device must be current limited to 20 mA 24 VDC Not current limiting current could result in damage to detector or cause a no alarm condition Wiring Terminals for the NS4 and NS6 are identical Wiring Terminals for the 4 and 6 are identical RELAY OPERATION Series Listed Base Relays shown with power off of Line Device 1 2W Fike Corporation All rights reserved No previously 1176 are subject change without notice