DSC AMP-701NP – Addressable Contact Input Module – Installation Manual – En – Ch

AMP-701NP Contact Input Module Instructions AMP-701NP contact uses a 2-wire connection for power and to communicate with control panel. This simplifies wiring and reduces installation cost. The low current of AMP-701NP also maximizes the number of devices that can be attached to an loop. AMP-701NP has three alarm input wires to which an external device can be con- The wires monitor alarm, tamper and trouble states. Use only devices with NC contact outputs. The use of any other type of device will impair the operation of the Current Rating: 0.8mA Operating Environment: – 49 (32 – 120 – 95% RH, non-condensing Panel Compatibility 4020 v3.x PC5010/5015 v2.x with PC5100 interface module PC5020 V3.2+ with PC5100 interface module Diagram Enrollment Number serial number located on the front of the device must be enrolled into the alarm panel via Installer Programming ([*] [8] [Installer Code]). This procedure is for the PC4020 in the control panel Installation Manual and for the Power in the PC5100 Installation Manual. WARNING (cid:129) only DSC Addressable Series devices to the addressable loop Connection of ANY other type of device will impair opera- Any devices other than Addressable Series devices which require to operate must be powered separately. manual shall be used in conjunction with the Installation Manual of the alarm con- panel. All the instructions specified within that manual must be observed. – READ CAREFULLY: DSC Software purchased with or without Products and Components copyrighted and is purchased under the following license terms: Warranty Security Controls warrants that for a period of 12 months from the date of the product shall be free of defects in materials and workmanship under use and that in fulfilment of any breach of such warranty, Digital Security shall, at its option, repair or replace the defective equipment upon return the equipment to its repair depot. This warranty applies only to defects in parts workmanship and not to damage incurred in shipping or handling, or damage to causes beyond the control of Digital Security Controls such as lightning, voltage, mechanical shock, water damage, or damage arising out of alteration or improper application of the equipment. foregoing warranty shall apply only to the original buyer, and is and shall be in of any and all other warranties, whether expressed or implied and of all other or liabilities on the part of Digital Security Controls. Digital Security neither assumes responsibility for, nor authorizes any other person pur- This End-User License Agreement ( is a legal agreement between You (the com- individual or entity who acquired the Software and any related Hardware) and Digital Controls, a division of Tyco Safety Products Canada Ltd. ( the manufacturer the integrated security systems and the developer of the software and any related prod- or components ( which You acquired. If the DSC software product ( PRODUCT or is intended to be by HARDWARE, and is NOT accompanied by new HARDWARE, You may use, copy or install the SOFTWARE PRODUCT. The SOFTWARE PRODUCT includes software, and may include associated media, printed materials, and or documentation. Any software provided along with the SOFTWARE PRODUCT that is associated with a sep- end-user license agreement is licensed to You under the terms of that license agree- INSTALLING, COPYING, DOWNLOADING, STORING, ACCESSING OR OTHERWISE USING SOFTWARE PRODUCT, YOU AGREE UNCONDITIONALLY TO BE BOUND BY THE TERMS THIS EULA, EVEN IF THIS EULA IS DEEMED TO BE A MODIFICATION OF ANY PREVIOUS OR CONTRACT. IF YOU DO NOT AGREE TO THE TERMS OF THIS EULA, DSC UNWILLING TO LICENSE THE SOFTWARE PRODUCT TO YOU, AND YOU HAVE NO RIGHT USE IT. PRODUCT LICENSE SOFTWARE PRODUCT is protected by copyright laws and international copyright as well as other intellectual property laws and treaties. The SOFTWARE is licensed, not sold. GRANT OF LICENSE This EULA grants You the following rights: