DSC BV-300DP-Installation Sheet–Trilingual

R Immune -PIR Instructions Digital Bravo3P PIR detector is specifically designed to provide optimum catch per- and enhanced false alarm prevention in environments containing pets. It uti- digital technology, a microprocessor, Multi Level Signal Processing (MLSP)*, dual operating parameters, automatic tempera- compensation and a unique pet rejection lens to provide effective and reliable detection of human motion and good protection nuisance alarm associated with pets weighing up to 60lbs (27.3kg). detector also provides excellent immunity to such false alarm producing influences as RF, static and electrical transient. This plus exceptional design care and careful factory testing, ensure years of trouble free performance. by the following patents: Canada 2099971 US 5444432 The Detector Bravo3P provides effective immunity to single or multiple pets whose total combined weight does not exceed 60lbs when installed and configured in the following manner. a detector location that will provide the coverage required and will allow the detector to be mounted a minimum of 6.5ft high and not higher than 10ft (3 m) (7.5ft/2.3m recommended). Consider the following to avoid false alarms: Do not aim the detector at a stairway which a pet has access to. Do not place furniture or objects higher than 3 ft/0.9 m, a pet can climb onto (e.g. a cat on a couch), closer than 6 ft/1.8 m to the detector. Mount the detector flat on a wall or in a corner. Do not angle it downwards or use mounting brackets with this detector. Do not aim the detector at reflective surfaces such as mirrors or windows as this may distort the coverage pattern or reflect sun- directly onto the detector. Avoid locations that are subject to direct high air flow such as near an air duct outlet. Do not locate the detector near sources of moisture such as steam or oil. Do not locate the detector in the path of direct or reflected (mirror) sunlight. Do not limit the coverage by having large obstructions in the detection area, such as plants or cabinets. open the case, use a small flat blade screwdriver and gently push in the tab at the bottom of the case and pull the cover out at the bottom. Loosen the PCB screw, and push the board up as far as it will go. Using a small screwdriver, remove appropriate knockouts for the mounting screws. Remove the left and/or right wiring entrance knockouts located at the top of backplate. Mount the backplate using the appropriate mounting screws (not supplied). Adjustment achieve the catch performance and pet immunity capabilities of the Digital Bravo3P the PCB board of the unit must be posi- so that the vertical adjustment scale on the board is set to zero . that the PCB retaining screw is tightened just enough to prevent board movement. are two jumpers on the detector circuit board. J2 is used to configure the detector to the weight of the pet(s) in the environment. For an environment with a single whose weight does not exceed 30lbs (13.6 kg) the unit should be set to “normal” (J2 ON). In an environment with single multiple pets whose combined weight is greater than 30lbs (13.6 kg) and not greater than 60lbs (27.3 kg) set J2 to “hostile” OFF). J1 will enable/disable the alarm LED. If J1 is OFF, the LED will not operate on alarm. If J1 is ON the LED will operate on power up, if J1 is ON, the LED will blink on and off at one second intervals for 90 seconds to indicate warm-up period. Testing NOTE: Upon installation, the unit should be thoroughly tested to verify proper operation. The detector should be tested weekly by the end user and annually by the installer. the animal(s) within the coverage area of the detector and then move out of the zone. Encourage the pet to move around it normally would and ensure that it moves across the detection pattern of the detector. Verify that no alarm is initiated. test for catch performance of humans, create motion in the entire area where coverage is desired by walking perpendicular to lens pattern. Should the coverage be incomplete, readjust or relocate the detector. coverage is as required, the alarm LED may be disabled by setting J1 to OFF. Pet Immunity has not been verified by UL. Immune -PIR d d num PIR Bravo est sp con pour offrir une performance de optimale et am la pr des fausses alarmes dans des milieux ayant des domestiques. Il utilise la technologie num