DSC HS-VM1100 – Installation Manual – English – Concourse Mono Video Modulator

Warranty Security Controls Ltd. warrants that for a period of 12 months from the date of purchase, the product be free of defects in materials and workmanship under normal use and that in fulfillment of any breach of warranty, Digital Security Controls Ltd. shall, at its option, repair or replace the defective equipment upon of the equipment to its repair depot. This warranty applies only to defects in parts and workmanship and to damage incurred in shipping or handling, or damage due to causes beyond the control of Digital Secu- Controls Ltd. such as lightning, excessive voltage, mechanical shock, water damage, or damage arising of abuse, alteration or improper application of the equipment. foregoing warranty shall apply only to the original buyer, and is and shall be in lieu of any and all other whether expressed or implied and of all other obligations or liabilities on the part of Digital Security Ltd. Digital Security Controls Ltd. neither assumes responsibility for, nor authorizes any other person to act on its behalf to modify or to change this warranty, nor to assume for it any other warranty or concerning this product. no event shall Digital Security Controls Ltd. be liable for any direct, indirect or consequential damages, loss anticipated profits, loss of time or any other losses incurred by the buyer in connection with the purchase, or operation or failure of this product. Digital Security Controls Ltd. recommends that the entire system be completely tested on a regu- basis. However, despite frequent testing, and due to, but not limited to, criminal tampering or electrical dis- it is possible for this product to fail to perform as expected INFORMATION: Changes or modifications not expressly approved by Digital Security Controls could void the user authority to operate this equipment. Compliance Statement Changes or modifications not expressly approved by Digital Security Controls Ltd. could void your to use this equipment. equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a res- installation. This equipment generates, uses and can radiate radio frequency energy and if not installed used in accordance with the Instructions, may cause harmful interference to radio communications. However, is no guarantee that interference will not occur in a particular installation. If this equipment does cause harm- interference to radio or television reception, which can be determined by turning the equipment on and off, the is encouraged to try to correct the interference by one or more of the following measures: Reorient the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/ TV technician for help. user may find the following booklet prepared by the FCC useful: to Identify and Resolve Radio/Television Problems This booklet is available from the U.S. Government Printing Office, Washington D.C. Stock # 004-000-00345-4. device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This may not cause harmful interference, and (2) this device must accept any interference received, including that may cause undesired operation. Home Systems is a division of Digital Security Controls Ltd. Digital Security Controls Ltd. Canada (cid:127) www.dsc.com in Canada 29034471 R002 Channel Frequency Agile Modulator Instructions 1 1 Adaptor Patch Cord Patch Cord HS-VM1100 is a one-channel monaural frequency agile audio/video modulator. modulator adds an RF (video) signal from security cameras or other video to your video distribution network using an unused channel. The HS- covers UHF channels 14 to 78 and CATV channels 65 to 135. of Package 1 1 Frequency Range: …………………………..470MHz 860MHz Channels: ……………………………………..UHF: CH14-78, CATV: CH65-135 Frequency Response:…………………………+/- 1dB Intercarriers Stability: …………………………4.5MHz w/n +/- 3KHz Input Imp/RF Output Imp: ………………