DSC PC5320_IN_EN_NA_29005945R005

FCC Compliance Statement Changes or modifications not expressly approved by Digital Security Controls could void your authority to this equipment. equipment generates and uses radio frequency energy and if not installed and used properly, in strict accordance with manufacturer instructions, may cause interference to radio and television reception. It has been type tested and found comply with the limits for Class B device in accordance with the specifications in Subpart of Part 15 of FCC Rules, are designed to provide reasonable protection against such interference in any residential installation. However, is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to or radio reception, which can be determined by turning the equipment off and on, the user is encouraged to try to the interference by one or more of the following measures: Re-orient the receiving antenna Relocate the alarm control with respect to the receiver Move the alarm control away from the receiver Connect the alarm control into a different outlet so that alarm control and receiver are on different circuits. necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. user may find the following booklet prepared by the FCC helpful: to Identify and Resolve Radio/Television Problems This booklet is available from the U.S. Government Printing Office, Washington, D.C. 20402, # 004-000-00345-4. Warranty Security Controls (DSC) warrants that for a period of one year from the date of purchase, the product shall be free defects in material and workmanship under normal use and that in fulfillment of any breach of such warranty, DSC at its option, repair or replace the defective equipment upon return of the equipment to its repair depot. This warranty only to defects in materials and workmanship and not to damage incurred in shipping or handling, or damage due causes beyond the control of DSC, such as lightning, excessive voltage, mechanical shock, water damage or damage out of abuse, alteration or improper application of the product foregoing warranty shall apply only to the original buyer, and shall be in lieu of any and all other warranties, whether or implied and of all other obligations or liabilities on the part of DSC. This warranty contains the entire war- DSC neither assumes responsibility for, nor authorizes any other person purporting to act on its behalf, to modify or change this warranty, nor to assume for it any other warranty or liability concerning this product. no event shall DSC be liable for any direct, indirect or consequential damages, loss of anticipated profits, loss of time or other losses incurred by the buyer in connection with the purchase, installation or operation or failure of this product. recommends that the entire system be completely tested on a regular basis. However, despite frequent testing, and to but not limited to criminal tampering or electrical disruption, it is possible for this product to fail to perform as This equipment is fixed and shall be installed by Service Persons only (service person is defined as a having the appropriate technical training and experience necessary to be aware of hazards to which person may be exposed in performing a task and of measures to minimize the risks to that person or persons). It shall be installed and used within an environment that provides the pollution degree max over voltages category II, in non-hazardous, indoor locations only. manual shall be used in conjunction with the Installation Manual of the alarm control panel. All the specified within that manual must be observed. 2005 Digital Security Controls Canada (cid:127) www.dsc.com Support: 1-800-387-3630 (Canada & US), 905-760-3036 in Canada Multiple Wireless Receiver Module Instructions PC5320 connects to the primary Keybus of a control panel* and provides four secondary 4-wire con- for up to four wireless receivers. The PC5320 does not provide additional zones but enables the 32 to be distributed over a greater area. When programming the first wireless receiver module informa- all of the information is stored identically in all of the connected modules. 1 PC5320 Module. Voltage Range…12VDC – 14VDC Current…55mA, plus current draw of each receiver module connected. Receiver Modules PC5132-4