
File preview
Click below to download immediately for free
File data
- Filename: 6521370948_DSC_PG9911-8911-4911_Installation_Manual_En-Fr-Sp-Po_-_29008699R003.pdf
- File size: 5 MB
- File type: pdf
- Download count: 62
Text Preview
D-305318 Wireless PowerG Outdoor Installation Instructions PGx911 is a fully supervised, 2-way wireless outdoor siren, for installation in areas in which wiring action is difficult or Built-in link quality indicators reduce installation time by the need for the installer to physically approach the controller. Power supply is dual, non-rechargeable batteries. Multiple sound types: Burglar (between 1400Hz – 3200Hz), fire, and flood. Entry/Exit beep can be enabled via the control panel to sound the user has armed the system and once the user has entered protected area. Squawk (beep) sounds can be configured via the control panel to alarm system arming (1 squawk) and disarming (2 by a wireless key. Double Tamper protection sends a tamper alarm to the system if siren front panel is removed or if the siren is removed from wall. Pressing the self-test button momentarily activates the LEDs and indicating the siren is operating correctly. Sounder is activated for a predefined duration according to requirements, or until the system is disarmed. The strobe light as described in the HSM2HOST installation manual. Siren and strobe light activates when an event message is from the system. If the siren is tampered with while armed, the siren transmits a message to the control panel. The control panel whether to activate the siren. If the siren does not an acknowledge message from the alarm system, the siren independently. When the battery voltage is low, a low battery message is sent to alarm system. After message delivery, at least 2 siren alarms possible before the siren battery is totally depleted. Setup To be installed by service persons in non-hazardous only. Risk of explosion if battery is replaced by an incorrect Observe polarity when installing batteries. Dispose of used according to the manufacturer instructions and according to rules and regulations. Batteries are to be replaced by service persons only. The PGx911 siren must be installed on the wall in a position with the screw pointing to the floor only. The of correct positioning of the PGx911 is to enable the siren function as a waterproof device. Ice and snow may block siren and affect audibility. Please inspect and clean regularly. To ensure the continued operation of all wireless devices after a system default, a global upload of all wireless via DLS is recommended before defaulting the system. completing wireless Cover Screw Battery Cover Catch Battery Cover Self-Test button Enroll button Secondary battery Battery connector Dual battery cable adapter system default, download battery or replacing the batteries Loosen plastic cover screw and remove the cover. (A) Release catch (B) and open battery cover (C). Using the cable adapter, connect batteries to the proper connec- (l) When manually programming wireless devices, if a device has powered up for more than 48 hours it cannot be enrolled into the until the device has been tampered and restored. When the panel using the Quick Enroll procedure follow the detailed in Enroll the Device into the System. After restoring a low battery trouble the system may take to 5 minutes to clear the trouble. the Device into the System quick enroll: On a keypad press [*] [8] [Installer Code] [804] [000]. Press and hold the device enroll button until the LED lights and then release the enroll button while the LED is still lit. confirmation message then appears on the keypad. Press [*] key to confirm ID. Enter [3 digit siren #]. Enter [1 digit partition #] for all desired partitions and press [#]. If an LCD keypad you can scroll to the desired partitions and [*] to toggle the partition. On an LCD keypad enter the label by using word library. pre-enroll: Remotely configure the unique ID number into the system. For information see the HSM2HOST manual. When on-site, press the device enroll button. If the wireless device has been powered for more than 48 hours being enrolled, tamper and restore the device to enroll it.