Reset Panel to Factory Default (Power432), PC1555 (Power632), PC5010 (Power832), PC5020 (Power864) PowerSeries panel can be defaulted, provided installer lockout is not enabled. There are ways to default the panel: a software default and a hardware default. Default Main Panel (Hardwire) factory default the main control panel perform the following: 1 Remove AC and battery from the panel 2 Remove all wires from the Zone 1 and PGM1 terminals 3 With a piece of wire short the Zone 1 terminal to the PGM1 terminal 4 Apply AC power to the main panel 5 Zone light 1 will turn ON when the default is complete (approx. 30 seconds) 6 Remove AC power from the panel 7 Reconnect all original wiring and power up the control panel normally Only the main panel will default. All modules will not be affected. Default Main Panel (Software) factory default the main control panel perform the following: [*] [8] [Installer Code] [999] [Installer Code] [999] again Installer Programming Section Factory Default panel will take a few seconds to perform the default. When the keypad is again operational default is complete. Only the main panel will default. All modules will not be affected.