DSC REM IRC UM EN NA COMMUNIQUE R000

File Preview
File Preview
Click below to download for free

File Data

Name dsc-rem-irc-um-en-na-communique-r000-6937125048.pdf
Type PDF
Size 615.65 KB
Downloads

Text Preview

IR Remote Instructions Page Music From the idle state press this key to turn background the idle state press this key to initiate an All Page key Communiqu IR Remote can be used to operate any telephone connected to the Communiqu system IR remote must be pointed at the telephone you wish operate Given battery strength and the room you should be able to operate the telephone the IR remote from 12 15 feet away 3.5 4.5m IR remote can only operate one Communiqu at a time an Incoming Call the telephone is ringing point the remote towards nearest Communiqu telephone and press the The call will be heard through the Communiqu handsfree speaker To terminate the press the Call Another Station call another internal station press the for an internal dial tone through the handsfree Enter the station number For example for 12 press Call an Outside Number call an outside number press the the station Prime Line To select another line the dial tone enter the telephone number on the remote number pad Calls place an outside call on hold press the retrieve a call from hold press the present press Q 8 followed by the line number of the call on hold 1 8 the Message Center retrieve mailbox messages press the dial tone present press the enter a mailbox number and a PIN number if required Follow the voice prompts over the Handsfree speaker To select a new mailbox press 6 telephone functions are available using the IR remote Each is listed in the below key followed by 8 1 to 8 8 for lines 1 8 When you hear an key and listen for internal dial tone With key The Communiqu will now prompt you for internal dial tone With internal dial and then enter 1 2 key followed by the key This will key key Not Disturb Open this key to turn the Do not Disturb mode on or off for selected Communiqu telephone connected to a door station press this key to the electronic door strike if installed the idle state press this key to redial the last number from that telephone station a busy signal is heard press this key to continue that number until it is no longer busy Intensity Switch on or off these keys to adjust the volume of the Handsfree this key to adjust the backlighting of the keys on the this key to adjust the intensity of the lit red keys on telephone the idle state press this key to access your security if installed the idle state press this key to access your home features if installed switch between pulse and tone dialing press this key more information on any of the features listed above consult your Communiqu Manual WARRANTY Security Controls Ltd warrants that for a period of twelve months from the date of purchase the shall be free of defect in materials and workmanship under normal use and that in fulfilment of any of such warranty Digital Security Controls Ltd shall at its option repair or replace the defective upon return of the equipment to its repair depot This warranty applies only to defects in parts workmanship and not to damage incurred in shipping or handling or damage due to causes beyond control of Digital Security Controls Ltd such as lightning excessive voltage mechanical shock water or damage arising out of abuse alteration or improper application of the equipment foregoing warranty shall apply only to the original buyer and is and shall be in lieu of any and all warranties whether expressed or implied and of all other obligations or liabilities on the part of Security Controls Ltd This warranty contains the entire warranty Digital Security Controls Ltd assumes nor authorizes any other person purporting to act on its behalf to modify or to change warranty nor to assume for it any other warranty or liability concerning this product no event shall Digital Security Controls Ltd be liable for any direct indirect or consequential damages of anticipated profits loss of time or any other losses incurred by the buyer in connection with the installation or operation or failure of this product Digital Security Controls Ltd recommends that the entire system be completely tested on a basis However despite frequent testing and due to but not limited to criminal tampering or disruption it is possible for this product to fail to perform as expected COMPLIANCE STATEMENT Changes or modifications not expressly approved by Digital Security Products Ltd could void your to use this equipment equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential This equipment generates uses and can radiate radio frequency energy and if not installed and used in with the instructions may cause harmful interference to radio communications However there is no that interference will not occur in a particular installation If this equipment does cause harmful interference radio or television reception which can be determined by turning the equipment off and on the user is encouraged try to correct the interference by one or more of the following measures Re orient the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio television technician for help user may find the following booklet prepared by the FCC useful to Identify and Resolve Radio Television Problems This booklet is available from the U S Government Printing Office Washington D C 20402 004 000 00345 4 Security Products Ltd 160 Washburn St Lockport NY 14094 Products Digital Security Controls Ltd Flint Road Downsview Ontario Canada M3J 2J6 665 8460 1 800 387 3630 in Canada 29002765 R0

Related Files