System Sensor PR-2 and PR-3 Manual

File Preview
File Preview
Click below to download for free

File Data

Name system-sensor-pr-2-and-pr-3-manual-3465709128.pdf
Type PDF
Size 1.02 MB
Downloads

Text Preview

INSTALLATION INSTRUCTIONS Relay Voltage Current Temperature Range Temperature Range Length Ratings to 40 VDC mA max to 158 to 70 to 185 to 85 to 93 RH non condensing min 203 mm x 1.65 x 1.22 mm H x 42 mm W x 31 mm D 5 wire nuts 7 wire nuts piece of double sided tape 11 4 screw VAC VAC VAC VDC max resistive load max 0.35 PF max resistive load max resistive load This manual should be left with the owner user of this equipment DESCRIPTION PR 2 and PR 3 are epoxy encapsulated single pull double throw SPDT that are activated by 10 to 40 VDC The PR 2 also uses a red LED as a indication of relay coil energization The PR 3 contains an additional and red wire used for redundant power input ease of installation the PR 2 PR 3 relays may be mounted in a variety of They can be attached within compatible equipment or in a separate using a mounting screw Double sided tape is also provided for support All wiring must conform to applicable local codes ordinances and PR 2 PR 3 connections are shown on the label on the side of the relay the enclosed wire nuts secure the electrical connections appropriate the application Provisions must be taken to separate power limited and limited wiring per National Electrical Code requirements Field wiring connected to the product must have a minimum 1 4 inch between the power limited and non power limited wire 3825 Ohio Avenue St Charles Illinois 60174 FAX 630 377 6495 DEFINITIONS RELAY NORMALLY CLOSED RELAY NORMALLY OPEN INPUT INPUT COMMON Wire Wire Wire Wire Wire LIMITED WARRANTY Sensor warrants its enclosed relay to be free from defects in materials and under normal use and service for a period of three years from date of System Sensor makes no other express warranty for this relay No agent dealer or employee of the Company has the authority to increase or the obligations or limitations of this Warranty The Company obligation of this shall be limited to the repair or replacement of any part of the relay which found to be defective in materials or workmanship under normal use and service the three year period commencing with the date of manufacture After phoning Sensor toll free number 800 SENSOR2 736 7672 for a Return Authorization send defective units postage prepaid to Honeywell 12220 Rojas Drive Suite El Paso TX 79936 USA Please include a note describing the malfunction and cause of failure The Company shall not be obligated to repair or replace which are found to be defective because of damage unreasonable use modi or alterations occurring after the date of manufacture In no case shall the be liable for any consequential or incidental damages for breach of this or other Warranty expressed or implied whatsoever even if the loss or damage is by the Company negligence or fault Some states do not allow the exclusion limitation of incidental or consequential damages so the above limitation or exclu may not apply to you This Warranty gives you specific legal rights and you may have other rights which vary from state to state System Sensor 06 10

Related Files