To Install the Annunciator Driver Module: the short end of the spacer through the of the ADM-12 as Driver Module Installation Drawing 15634, Rev A 1/6/93 ECN 93-06 Hold the ADM-12 upright over the right-hand corner of the Begin inserting the free end of nylon spacer hole at upper right-hand corner of (to the left of the mounting while carefully aligning the board’s connector over pin header J3. Press on the board until the spacer and snap into place. spacer in hole, lining up pin at J3 Use the diagram below to connect from an RZA-5F Remote to the ADM-12. Clintonville Road, Northford, CT 06472 (203) 484-7161 FAX: (203) 484-7118 1 – Installation
