ANN-100 Character LCD Fire Annunciator ANN-100 annunciator is a backlit, 80-character LCD fire annun- that mimics the Fire Alarm Control Panel (FACP) display. It system status indicators for AC Power, Alarm, Trouble, and Alarm Silenced conditions. ANN-100 and the FACP communicate over a two-wire serial employing the ANN-BUS communication format. Con- devices are powered, via two additional wires, by either the FACP or a remote UL-listed, filtered power supply. ANN-100 displays English-language text of system point infor- including device type, zone, independent point alarm, trouble supervisory status, as well as any custom alpha labels pro- into the control panel. It includes control switches for control of critical system functions. (A keyswitch prevents operation of the control switches.) to eight ANN-100s may be connected to each ANN-BUS of a No programming is required, which saves time during system Listed to UL Standard 864, 9th Edition Backlit 80-character LCD display (20 characters x 4 lines) Mimics all display information from the host panel Control switches for Signal Silence, System Acknowledge, Reset, Control switches can be independently enabled or disabled at the Drill Keyswitch enables/disables control switches and mechanically annunciator enclosure Keyswitch can be enabled or disabled at the FACP Enclosure supervised for tamper System status LEDs for AC Power, Alarm, Trouble, Supervisory, Alarm Silence Local sounder can be enabled or disabled at the FACP ANN-100 connects to the ANN-BUS terminal on the FACP and minimal panel programming Displays device type identifiers, individual point alarm, trouble, zone, and custom alpha labels Time-and date display field Surface-mount or flush-mount installation options Optional trim ring for a more finished look Can be remotely located up to 6,000 feet (1,800 m) from the Backlight turns off during AC loss to conserve battery power but turn back on if an alarm condition occurs May be powered by 24 VDC from the host FACP or by remote supply (requires 24 VDC) Up to eight ANN-100s can be connected on the ANN-BUS and Indicators AC Power Alarm Trouble Supervisory Alarm Silenced Flush Mount: (Outside wall) 12.25 x 11.5 x 0.875 (31.1W 29.2H x 2.2D cm), (Inside wall) 9.375 x 8.375 x 2 x 21.3H x 5.1D cm) Surface Mount: (Including Trim Ring) 12.25 x 11.5 3 x 29.2H x 2.2D cm) Operating Voltage: 24VDC Standby Current: 20mA Alarm Current: 25mA Wiring Distance: Up to 6,000 ft max. from FACP All connections are power-limited and supervised. For use indoors in a dry location. Relative humidity: 93% 2% RH (non-condensing) at 32 2 Ambient temperature: 32 to 120 (0 to 49 3 Listings and Approvals listings and approvals below apply to the ANN-100. In some certain modules may not be listed by certain approval agen- or listing may be in process. Consult the factory for the latest status. S2424 approved 7165-0075:0500 COA #6261 Information 80 character remote fire annunciator; red Optional trim ring for surface-mount applications; red 1/22/2019 Page 1 of 2 Alarms is a registered trademark of Honeywell International Inc. by Honeywell International Inc. All rights reserved. Unauthorized use of this is strictly prohibited. document is not intended to be used for installation purposes. We try to keep our product information up-to-date and accurate. cannot cover all specific applications or anticipate all requirements. specifications are subject to change without notice. more information, contact Fire Alarms.