Fire-Lite CHG-120F

CHG-120F Charger CHG-120F is a state-of-the-art battery charging system for use with Fire fire alarm control panels It is designed to charge lead-acid batteries between and 120 ampere-hours (AH). Charges sealed lead-acid batteries. Automatic float-type battery charger. Rated for batteries of 25 to 120 ampere-hours. Obtains full float voltage within 48 hours. For use on any 24-volt FACP which can handle the speci- batteries and can disable the local charger. AC Fail delay (central station applications) per latest NFPA Form-C Trouble contact. Dual outputs, for easy load distribution. Diagnostic LEDs: Primary AC On Charger Trouble. Ground Fault. Hi Charge. Lo Charge. Battery Voltage Level (3 LEDs). Low Battery. Black or red BB-55F(R) battery cabinet. Field-selectable input voltage, 120 VAC or 230 VAC. Charges: 26 AH batteries within 9 hours. 55/60 AH batteries within 20 hours. 120 AH batteries within 38 hours. Values per Fire testing. and Operation CHG-120F consists of a PC board and mounting chassis. current is provided automatically when the battery falls below the charger output voltage. the CHG-120F when batteries required for standby are between 25 to 120 AH. Specifications AC (TB1): 115 VAC, 60 Hz, 2 A. 230 VAC, 50 Hz, 1 A. relay (TB3): 5 A at 30 VDC. charge voltage: 27.6 VDC. charging current: 4.5 A. F1-F3: 15 A. sizes: 26 AH to 120 AH. D-225 Supplies/Accessories time (to charge two fully discharged batteries): 25 AH = 9 hours. 55 AH/60 AH = 20 hours. 120 AH = 38 hours. CHG-120F mounts remotely in the BB-55F Battery Back- Install the CHG-120F within 20 feet (6.096 m) of the main in the left position of the BB-55F backbox. Only one 55 AH battery or two 26 AH batteries will mount the charger board in the BB-55F. Battery Box Battery Configurations: The battery can mount configurations of batteries as follows: Without CHG-120F mounted internally: With CHG-120F mounted internally: Up to two 26 AH batteries. Up to two 55 AH batteries. One 100 AH battery. Up to two 26 AH batteries. One 55 AH battery. One 100 AH battery. When 100 AH batteries are required, a BB-55F is required mount each 100 AH battery. Line Information Battery charger circuit board and mounting chas- Includes mounting hardware and installation instructions. 26 AH, 12-volt, sealed lead-acid battery. Order as pack BAT-12260-BP, contains two. 55 AH, 12-volt, sealed lead-acid battery. 10/18/2012 Page 1 of 2 100 AH, 12-volt, sealed lead-acid battery. Battery Backbox holds up to two BAT-12550 55 AH or one BAT-121000 100 AH battery. Dimensions: 24.0″ (61.0 cm) wide x 14.0″ (35.6 cm) high x 7.75″ (19.7 deep. Door: 24.125″ (61.3 cm) wide x 14.25″ (36.2 cm) x (door adds 0.063″ [approx. 0.16 cm] to depth), black. Same as BB-55F above but painted red. with Codes and Standards CHG-120F complies with the following standards: NFPA 72 National Fire Alarm Code. UL 864 Standard for Control Units for Fire Alarm Systems. Features UL 1481 Power Supplies for Fire Alarm Systems. CAN/ULC-S527-M87. Listings and Approvals listings and approvals below apply to the basic CHG- In some cases, certain modules may not be listed by approval agencies, or listing may be in process. Con- factory for latest listing status. UL: S1287. ULC: CS100. CSFM: 7315-0075:0182. MEA: 195-97-E Vol. 2. Battery Backbox is a registered trademark of Honeywell International Inc. by Honeywell International Inc. All rights reserved. Unauthorized use this document