Fire-Lite CMF-300(A)

CMF-300(A) Module CMF-300(A) Addressable Control Module provides intelligent control panels a circuit for Notification (horns, strobes, etc.). Addressability allows the to be activated through panel programming, on a (zone or area of coverage) basis. is a communication protocol developed by Engineering that greatly enhances the speed of com- between analog intelligent devices. Intelligent communicate in a grouped fashion. If one of the within the group has new information, the panel CPU the group poll and concentrates on single points. The effect is response speed greater than five times that of designs. Built-in type identification automatically identifies these to the control panel. circuitry powered directly by two-wire SLC loop. CMF-300(A) module requires power (for horns, etc.). LED green each time a communication is from the control panel and turns on steady red activated. High noise immunity (EMF/RFI). The CMF-300(A) may be used to switch 24-volt NAC Wide viewing angle of LED. SEMS screws with clamping plates for wiring ease. Direct-dial entry of address: 01 159 for MS-9600 series 01 99 on MS-9200UDLS and MS-9050UD. CMF-300(A) is used to switch 24 VDC audible/visual The face plate is made of off-white heat-resistant plastic. Controls include two rotary switches for direct-dial entry of setting. The CMF-300(A) is configured for a single Class B (Style Y) Class A (Style Z) Notification Appliance Circuit. CMF-300(A) uses one of the module addresses on a loop. It responds to regular polls from the control panel reports its type and status, including the open/normal/ status of its Notification Appliance Circuit (NAC). The blinks with each poll received. On command, it activates internal relay. The CMF-300(A) supervises Class B (Style or Class A (Style Z) notification or control circuits. code command from the panel, the CMF-300(A) will dis- the supervision and connect the external power sup- in the proper polarity across the load device. The of the supervision provides a positive indication the panel that the control relay actually turned ON. The E-350 Devices power supply is always relay-isolated from the com- loop so that a trouble condition on the external supply will never interfere with the rest of the system. switches set a unique address for each module. The may be set before or after mounting. The built-in CODE (not settable) will identify the module to the con- panel, so as to differentiate between a module and a sen- address. operating voltage: 15 to 32 VDC. SLC current draw: 6.5 mA (LED on). operating current: 350 direct poll (CLIP mode), group poll (LiteSpeed mode) with LED flashing. supply voltage: maximum 80 volts (RMS or DC). on external supply: 2 mA maximum (using internal relay). resistance: 47K ohms. range: 32 to 120 (0 to 49 range: 10% to 93% non-condensing. 4.5″ (11.43 cm) high x 4″ (10.16 cm) wide x (3.175 cm) deep. Mounts to a 4″ (10.16 cm) square x (5.398 cm) deep box. Listings and Approvals some cases, certain modules may not be listed by certain agencies, or listing may be in process. Consult fac- for latest listing status. ULC: S2424 Line Information Intelligent addressable control module. 4/20/10 Page 1 of 2 Canadian intelligent addressable control Optional surface-mount backbox. Optional control module barrier, required by UL for power-limited and non-power-limited wiring in the junction box as CMF-300(A). For installation instructions, see document I56-1189-009 refer to the SLC Wiring Manual, document 51309. The CRF- relay module, previously on this