Fire-Lite ES-200X Datasheet

DF-60957:C Fire Alarm Control Panels Addressable FACP Communicator ES-200X is the latest intelligent addressable Fire Alarm Control (FACP) from Fire Alarms and is a direct replacement for MS-9200UDLS. The ES-200X comes with a pre-installed com- and supports up to 198 addressable devices (99 detec- and 99 modules). With an extensive list of powerful features, the programs just like Fire other addressable products, fits into applications previously served only by conventional pan- pre-installed IPOTS-COM is a dual technology (POTS and IP) The POTS transmits system status (alarms, troubles, loss, etc.) to a Central Station via the public switched telephone The IP communicator internet monitoring capability sends signals over the Internet saving the monthly cost of two dedi- business telephone lines. Although not required, the second- telephone line may be retained providing backup communication the public switched telephone line. Optional cellular reporting is using the CELL-MOD or CELL-CAB-FL. and local programming of the control panel is possible using FS-Tools Upload/Download utility. Programming databases can uploaded/downloaded via the panel USB port (and USB cable) via an ethernet connection using the IPOTS-COM communicator. USB port also allows for the download or upload of the entire history file, walk-test data, current status and system volt- by means of a USB flash drive. power supply and all electronics are contained on a circuit supported on a new quick install chassis and housed in a cabinet. Available accessories include local and remote software, remote annunciators, and reverse polar- box transmitter (4XTMF). Listed to UL Standard 864, 10th edition Pre-installed IPOTS-COM Ethernet IP and POTS (Plain Old Tele- Service) Central Station Communicator over AlarmNet Optional CELL-MOD or CELL-CAB-FL GSM Central Station over AlarmNet Automated activation of the ECC-50/100 Emergency Command ECC-FFT Firefighter Telephone option Compatible with SWIFT wireless devices Auto-programming (learn mode) reduces two devices set to the same address Four built-in, independently programmable Style Z (Class A) or Y (Class B) NAC circuits Selectable strobe synchronization for System Sensor, Wheelock, Gentex devices Notification Appliance Circuit End of Line resistor matching Four programmable function keys for ease of maintenance Two programmable relays and one fixed trouble relay Built-in Programmer Real-time clock/calendar with automatic daylight savings control History file with 1,000 event capacity Addressable sounder base compatibility Multi-criteria detector (smoke, heat, CO) with programmable 80-character LCD display with backlighting Control module delay timer Automatic detector sensitivity testing (NFPA 72 compliant) Automatic device type-code verification Point trouble identification Waterflow selection per module point Single addressable SLC loop which meets NFPA Class B and is excessive compliant) Alarm verification selection per detector point Maintenance alert warns when smoke detector dust accumula- One-person audible or silent walk test with walk-test log and System alarm verification selection per detector point PAS (Positive Alarm Sequence) and Pre-signal per point (NFPA Up to 16 ANN-BUS annunciators- 8 per each ANN-Bus Remote Acknowledge, Alarm Silence, Reset and Drill via modules or remote annunciator Upload/Download of program and data via USB with optional FS- Programming Utility COMMUNICATION LOOP Supports LiteSpeed and CLIP protocols SLC operates up to 10,000 ft. (3,000 m) in LiteSpeed mode with unshielded wire A requirements modules) Wiring Manual) 198 addressable device capacity (99 addressable detectors and Compatible with Fire addressable devices (refer to the APPLI