2UD Modem Card Instructions mIP-2 and the IPDACT-2 products can be converted to a mIP-2UD or to an (respectively) by installing the 2UD Modem Card. This will provide full Panel Upload/Download support over the IP network. 1. Adding the 2UD modem card to a mIP-2 or an IPDACT-2 module Before proceeding with the installation, make sure all power and DC) has been removed. installer should follow the steps described below: Remove the plastic label/cover from the IPDACT-2 Module. If the module is a mIP-2 Remove the jumpers from A and B pins located in the upper left portion of the mIP-2 step may not be required. the IPDACT-2 module. 2. Close-up of pins A and B in mIP-2 and IPDACT-2 modules Carefully align the connector on the 2UD Modem Card with the connector located in top left of the mIP-2 or the IPDACT-2 module and align the A and B connectors the 2UD Modem Card with the A and B pins on the mIP-2 or IPDACT-2 module removed in step 2). 3. Aligning the 2UD card with the mIP-2 or IPDACT-2 module Carefully press the 2UD Modem Card onto the mIP-2 or IPDACT-2 module Ensure that the 2UD Modem Card is securely seated, being careful not bend or break any pins on the connectors. Reinstall the plastic label/cover on the IPDACT-2UD Module. If the module is a mIP- this step may not be necessary. Reapply all power (AC and DC) and test the system for proper operation.