Fire-Lite MS-9600LS(E)_MS-9600UDLS(E)

MS-9600LS(E)/MS-9600UDLS(E) Addressable FACP Optional Second Loop A1-100 Control Panels MS-9600LS(E) and MS-9600UDLS(E) are compact, cost intelligent addressable FACPs (Fire Alarm Control Panels) an extensive list of powerful features. The combination of newer series devices and legacy 300 Series devices, with the MS-9600LS(E) or MS-9600UDLS(E) FACP, offer the in fire protection technology. LiteSpeed is a patented tech- that polls 10 devices at a time looking for new or different When new information is found at a specific address, system polls that device several times for any new data. This allows a fully loaded panel with up to 636 devices to an incident and activate the notification circuits in under 10 With this polling scheme, devices can be wired on stan- twisted, unshielded wire up to a distance of 10,000 feet per Each Signaling Line Circuit (SLC) loop supports up to 159 detectors including photoelectric, photoelectric with beam, ionization, photoelectric duct, fixed heat, fixed heat with and fixed high-heat detectors. It also supports up to 159 modules including monitor (two-wire detector, normally devices), dual-monitor functions (two monitor circuits from one two addresses used), multi-monitor (multiple monitor cir- from one module, multiple addresses used), control (for Notifi- Appliance Circuits), and relay (two Form-C) modules. FLPS-7 power supply is a separate board while all other elec- are contained on a single main circuit board. Both boards are to a quick-removable chassis and housed in a metal cabi- The backbox can be installed allowing field wiring to be pulled. construction is completed, the chassis with the electronics be quickly installed with two bolts. MS-9600UDLS(E) includes a factory-installed 2 Digital Alarm Transmitter. The DACT transmits system status troubles, AC loss, etc.) to a Central Station via internet IPDACT installed) or the public switched telephone net- modules, which plug into the main circuit board, are avail- for special functions. Available accessories include LED, and LCD annunciators, reverse polarity/city box transmitter, alarm communicator/transmitter, SLC expansion module, and remote upload/download software and remote power APPROVED to UL ANSI 864. Unless otherwise specified, the term MS-9600LS is used in this to refer to the MS-9600LS, MS-9600UDLS, MS-9600LSE, and FACPs (Fire Alarm Control Panels). And Indicators INDICATORS AC POWER (green) FIRE ALARM (red) SUPERVISORY (yellow) ALARM SILENCED (yellow) SYSTEM TROUBLE (yellow) MAINTENANCE/PRESIGNAL (yellow) DISABLED (yellow) BATTERY FAULT (yellow) GROUND FAULT (yellow) SWITCH CONTROLS ACKNOWLEDGE/STEP ALARM SILENCE DRILL SYSTEM RESET (lamp test) 12-key pad with full alphabet 4 cursor keys ENTER Features Easy mount chassis. 7 amp switching power supply. Large enclosure allows 18 amp-hour batteries 2 plug-in communicator standard with MS-9600UDLS/E. Optional IPDACT Internet Protocol Digital Alarm Communicator/ Four Style Y (Class B) or two Style Z (Class A) circuits. Selectable strobe synchronization per NAC for Sensor, Wheelock, and Gentex devices. Certified for seismic applications when used with the appropriate mounting kit Seamless integration between fire and mass notification with the Emergency Command Center via ANN-BUS con- ECC-FFT Firefighter Telephone Option ANN-BUS for connection to following optional modules cannot be used if ACS annunciators are used. ANN-80(-W) Remote LCD Annunciator ANN-I/O LED Driver Module ANN-S/PG Serial/Parallel Printer Module 2/20/2019 Page 1 of 6 ANN-RLY Relay Module ANN-LED Annunciator Module ANN-RLED Annunciator Module (alarms only) Compatible with SWIFT