Fire-Lite Teldat VisorALARM+ Alarm Receiver over IP

Receiver over IP INSTALLATION GUIDE 377-I, Version: 1.0 Introduction Quick Installation Guide is designed to help the installation process of the VisorALARM+ and is to quick reference and initial configuration; therefore this document contains information specific to aim and does not consider all possibilities. For further information on this please see the installation manual or contact the Teldat Security technical service. Requirements software Software compatible with Surgard, Radionics 6500 or Ademco 685 receivers and available RS-232 line. to an Ethernet network (10 or 100 Mbps). connection 110-240 V AC. with serial port (speed 9600, 8 data bits, without parity bits, 1 stop bit and without flow and terminal emulation software (e.g. Windows HyperTerminal). serial cable for configuration (DB9 male DB9 female). Connection and public1 IP address for the VisorALARM+. If Internet access is behind a NAT / firewall, you must have a private static IP address and a UDP port redirected to the said private address. Checklist Cables: Ethernet network cable, category 5. power supply cable. serial cable for configuration (DB9 male DB9 female). serial cable for transmission of alarms to the server (DB9 male DB9 female). Receiver Data: Information: of receiver to emulate (Surgard, Radionics 6500 or Ademco 685). and receiver identifier. address, subnet mask and gateway. port for alarm reception. RS-232 communication parameters: speed, data bits, parity bits and stop bit. Physical Connections switch or a hub in your network. Connect one end of the Ethernet network cable to the connector labeled LAN and the other end to Connect the female end of the configuration RS-232 cable to t he PC serial port and the male end the connector labeled AUX on the rear panel of the VisorALARM+. Connect the DB25 end of the data RS.232 cable to the AUT connector and the other end to the with the automation software. you have a printer connect the DB25 end of the printer RS232 cable to the PRN connector and other end to the serial printer. Connect the female end of the power supply cable to the power connector of the device and the end to a grounded socket. Configuration on the device. In the PC terminal emulator, you will see some information on device start-up. until information similar to that shown below is displayed: (c)2001-2004 model VISORALARM-PLUS EU 6 119 CPU MPC8260 S/N: 472/01349 LAN, 4 WAN Lines software version: 10.6.33 Feb 26 2007 14:18:00 this point the device is ready to be configured. The commands required for configuration are below and grouped by functionality. with default config you receive the device from factory it is shipped with a basic default configuration. If you wish defaults the device to this factory configuration use the default-config command. 4 default-conf your session changes will be lost. default configuration (Yes/No)?Y IP the following commands, substituting ip_address for the VisorALARM+ IP address, mask for network mask and gateway for the gateway IP address. ip Internet protocol user configuration — config>address ethernet0/0 ip_address mask config>route 0.0.0.0 0.0.0.0 gateway 1 config>classless config>exit the type of Alarm Receiver the udp-port for the alarm receiver. This is the receiver UDP port where the mIP devices send its registration and supervision data packets. serial0/0 ARLY Interface Configuration — Cfg>supervision port udp-port dependent on the emulated receiver: the commands required to configure the emulation of different receivers with their default parameters for communication with the automation server are below: Gard MLR-2000 / MLR2E Cfg> alarm-receiver protocol sur-gard Cfg> alarm-r