Fire-Lite ADM 12 Annun Driver Mod

To Install the Annunciator Driver Module the short end of the spacer through the of the ADM 12 as Driver Module Installation Drawing 15634 Rev A 1 6 93 ECN 93 06 Hold the ADM 12 upright over the right hand corner of the Begin inserting the free end of nylon spacer hole at upper right hand corner of to the left of the mounting while carefully aligning the board s connector over pin header J3 Press on the board until the spacer and snap into place spacer in hole lining up pin at J3 Use the diagram below to connect from an RZA 5F Remote to the ADM 12 Clintonville Road Northford CT 06472 203 484 7161 FAX 203 484 7118 1 Installation