Fire-Lite CRF-300 Relay Control Module Installation AND MAINTENANCE Instructions

InstallatIon anD maIntenance InstructIons relay control module Operating Voltage Current Draw Operating Current Resistance Range to 32 VDC LED on direct poll 255 group poll used to 120 0 to 49 to 93 Non condensing H 4 W 11 4 D Mounts to a 4 square by 21 8 deep box Electrical Box CB500 Barrier FireLite Place CT 06472 203.484.7161 CRF 300 mounts directly to 4 inch square electrical boxes see Figure 2A box must have a minimum depth of 21 8 inches Surface mounted electri boxes SMB500 are available 2a moDule mountIng BarrIer 2B InstallIng information is included as a quick reference installation guide Refer to control panel installation manual for detailed system information If the will be installed in an existing operational system inform the opera and local authority that the system will be temporarily out of service Dis power to the control panel before installing the modules This manual should be left with the owner user of this equipment DescrIptIon CRF 300 Relay Control Module is intended for use in addressable two systems where the individual address of each module is selected using built in rotary switches It allows a compatible control panel to switch contacts by code command The relay contains two isolated sets of contacts which operate as a DPDT switch and are rated in accordance the table in the manual Circuit connections to the relay contacts are supervised by the module The module also has a panel controlled LED This module can be used to replace an C304 module that has been for Form C operation requIrements ensure proper operation these modules shall be connected to listed com system control panels only 1 controls anD InDIcators All wiring must conform to applicable local codes ordinances and When using control modules in nonpower limited applications CB500 Module Barrier must be used to meet UL requirements for the sepa of power limited and nonpower limited terminals and wiring The bar must be inserted into a 4 junction box and the control module be placed into the barrier and attached to the junction box Figure 2A power limited wiring must be placed into the isolated quadrant of the barrier Figure 2B Install module wiring in accordance with the job drawings and appropri wiring diagrams the address on the module per job drawings Secure module to electrical box supplied by installer as shown in 2A contact ratIngs RATING VOLTAGE DESCRIPTION A A A A A A A A A A VDC VDC VDC VDC VDC VDC VAC VAC VAC VAC L R 5ms L R 2ms PF 35 PF 35 PF 35 PF 35 relay switch contacts are shipped in the standby state open state but may have transferred to the activated closed state during shipping To ensure that switch contacts are in their correct state modules must be made to communicate with the panel before connecting circuits controlled by the module 3 relay moDule wIrIng DIagram NEXT MODULES TO LISTED COMPATIBLE PANELS ONLY PANEL OR DEVICE LINE CIRCUIT SLC VDC MAX PAIR RECOMMENDED COMMON 2 CLOSED 2 OPEN 2 COMMON 1 CLOSED 1 ANY WIRING TO TERMINALS 4 10 IS NONPOWER THE CB500 BARRIER IS REQUIRED THE CB500 A NONPOWER LIMITED LABEL WHICH MUST PLACED OVER THE POWER LIMITED TERMINAL ON THE NAMEPLATE LABEL OPEN 1 MODULE DOES NOT SUPERVISE CONTROLLED CIRCUITS ANY FAULT IN THE POWER SUPPLY IS TO THAT ZONE AND DOES NOT IN A FAULT IN A SEPARATE ZONE Fire Lite Alarms Inc