Fire-Lite Duct Smoke Detector Accessories

Duct Smoke Detector smoke detector accessories add functionality to the duct system by allowing quick convenient inspections at eye and effective audible and visual notification options All Sensor duct smoke detectors and accessories are UL PIEZO ANNUNCIATOR APA151 piezo annunciator which replaces the APA451 a new improved look provides an audible alarm signal a LED to indicate alarm status and a green LED to indicate status It is intended for use with System Sensor 4 wire duct smoke detector applications without a system panel to comply with NFPA 90A SpectrAlert Advance Mini Horns Piezo Annunciator Voltage Voltage Alarm Current Range Humidity Gauge 24 VDC to 33 VDC mA to 120 0 to 49 to 93 non condensing to 18 AWG H x 2.9 W x 45 D MINI HORNS MHR and MHW SpectrAlert Advance mini horns feature or continuous tones at high and low volume settings small footprint allows mounting to single gang back for applications where a small device is desired Current Draw Range Range Sounder Frequency Gauge 12 DC or FWR Full Rectified or Regulated VDC or FWR to 33 VDC 9 to 33 VDC with Module mA RMS max at 8 to 17.5 DC mA RMS max at 8 to 17.5 FWR mA RMS max at 16 to 33 DC mA RMS max at 16 to 33 FWR to 120 0 to 49 to 93 non condensing kHz to 18 AWG x 2.9 x 0.45 1 27 12 Page 1 of 4 REMOTE ANNUNCIATORS RA100Z and RA100ZA remote annunciators are designed both conventional and intelligent applications Their red LED visual indication of an alarm condition Remote Annunciator Range Alarm Current System 3.1 to 32 System 18 to 32 mA x 2.8 x 1.3 REMOTE TEST STATIONS RTS151 and RTS151KEY remote test stations are auto fire detector accessories designed to test duct smoke from a convenient location For 4 wire detectors the test station features a multi colored LED that alter between steady green and red For 2 wire detectors the illuminates red for alarm Remote Test Station with Key Requirements Response Time Range Humidity Gauge LED Green 14 to 35 12 mA max LED RED 2.8 to 32 12 mA max seconds max to 140 10 to 60 non condensing to 18 AWG x 2.75W x 1.8 MULTI SIGNALLING ACCESSORIES RTS2 and RTS2 AOS multi signaling accessories are to work with InnovairFlex 4 wire conventional duct detectors These accessories include a key switch that be used to select one of two connected sensors to be reset or both by a push button switch They also enable measurements using the SENS RDR sensitivity sold separately The AOS Add On Strobe is an accessory included with the RTS2 AOS model and RTS AOS Multi signaling Accessory Requirements Range Humidity Gauge to 29 VDC 3.0 mA max 16.0 mA max without Strobe 30 mA with Strobe 55 mA max dBA at 10 ft to 140 10 to 60 non condensing to 22 AWG x 5.3 x 1.6 Remote Test Station Requirements Switch Switch Response Time Range Humidity Gauge LED 2.8 to 32 VDC 10 max Current 95 mA max VA 32 VDC VA 32 VDC seconds max to 140 10 to 60 non condensing to 18 AWG x 2.9W x 1.4 2 of 4 DF 60536 B1 1 27 12 Listings and Approvals listings and approvals below apply to the basic products In cases certain modules may not be listed by certain agencies or listing may be in process Consult factory latest listing status UL S4011 APA 151 MHR MHW S2522 RTS2 RTS151 RTS151KEY RTS2 AOS FM Approved CSFM 7135 1653 0212 Line Information Piezo Annunciator Mini Horn Red Mini Horn White Remote Annunciator Remote Test Station Remote Test Station with Key Multi signaling Accessory Add On Strobe Multi Signaling Accessory and Humidity Ranges system meets NFPA requirements for operation at 0 120 and at a relative humidity 93 2 RH at 32 2 90 3 However the life of the system s standby batteries and the electronic may be adversely affected by extreme tempera ranges and humidity Therefore it is recommended that system and its peripherals be installed in an environment a normal room temperature of 15 27 80 1 27 12 Page 3 of 4 Alarms and System Sensor are registered trademarks of International Inc by Honeywell International Inc All rights reserved Unauthorized use this document is strictly prohibited document is not intended to be used for installation purposes We try to keep our product information up to date and accurate cannot cover all specific applications or anticipate all requirements specifications are subject to change without notice more information contact Fire Alarms Phone 800 627 3473 FAX 877 699 4105 in the U S A 4 of 4 DF 60536 B1 1 27 12