Fire-Lite FC PSM Voice Evac Power Supply Battery Charger Module

The FC PSM E Power Supply Battery Charger Module can be used to stand alone power to the Voice Evacuation Control Panel The requires 120 VAC 60 Hz 1.0 amps The FC PSME requires VAC 50 Hz 0.5 amps In addition to supplying operating the modules are capable of charging 7 AH to 17 AH batteries Evacuation Control Panel Power Supply Battery Module Installation Drawing 50612 Rev B 8 8 97 ECN 97 303 Make certain all power AC and DC is removed before any connections are made Power Supply Battery Charger Module Installation Remove two mounting screws from the top left and bottom left corners of the main circuit board largest circuit board closest to cabinet back Install two short metal standoffs which are supplied with the FC PSM E Power Supply Battery Charger Module by screw them into the top left and bottom left corners of the main circuit board where the screws were removed in Step 1 Install the two supplied long metal standoffs by screwing them onto the threaded mounting studs in the top and bottom rails in the back box The mounting studs are located to the far left on each rail refer to illustrations on following Remove the factory installed jumper from connector P7 of the main circuit board P7 is located on the bottom left corner the main circuit board refer to illustration below Carefully align connector J1 on the FC PSM E Power Supply Battery Charger Module with connector P7 on the main board and press the FC PSM E securely into place Make certain the pins are properly aligned to prevent bending or any pins Secure the FC PSM E to the standoffs using the two screws removed in Step 1 and two supplied screws It is important that module be secured with the metal screws in order to help protect against lightning electrical transients Continue with the FC PSM E transformer installation as described on the following page 2 3 Standoff 1 2 3 factory jumper installing the Module 2 3 Standoff 1 2 3 Standoff Power Supply Charger Module Evacuation Control Panel Circuit Board Remove two mounting screws from main board upper and lower left corners Main Circuit Board Install four metal standoffs by screwing place note two different lengths Install FC PSM E Module and with four screws Circuit Main Circuit Board Backbox Mounting Rails Backbox Mounting Rails Backbox Mounting Rails Make certain all power AC and DC is removed before any connections are made Transformer Installation Locate two threaded mounting studs in the bottom left corner of the backbox refer to backbox illustration below Position XRM 24 E Transformer Assembly over mounting studs Transformer should be oriented so the cable assembly is the left as illustrated below Secure Transformer to the studs with the two supplied nuts Do not tighten one nut until the next step Connect a wire from a solid earth ground to one of the Transformer mounting studs and tighten the nut This connection is in order to provide proper lightning and transient protection for the panel Plug the XRM 24 E Transformer cable assembly into connector P1 which is located in the lower left corner of the Power Supply Battery Charger Module Note that the Transformer cable connector is keyed to prevent connection Complete the installation by connecting the AC power wires to the Hot Neutral and Earth terminals of TB1 on the Power Supply Battery Charger Module If batteries are being used connect the batteries 17 AH max to connector P2 located to the left center of the FC PSM E Supply Battery Charger Module Apply power to the panel Connector Connector Ground Connection AC Terminal Transformer Assembly Evacuation Control Panel VECP Backbox Mounting Rail Top Mounting Locations Mounting Rail Bottom Mounting Studs Backbox of 2 50612 Rev B ECN 97 303 8 8 97