Fire-Lite Gentex AVS44 Synchronization Module

July 28 1998 AVS44 Control Module the GOT GOS Series Horn Horn Strobe Audio Visual Devices Vol XII Fire Gentex AVS44 Synchronization Control Module is to provide an easy way to synchronize multiple as well as strobe light flashes using only two wires in rare instances where a synchronized flash is required control module has the ability to synchronize mul horn signals with a Code 3 temporal pattern at 800 or 2400 Hz the 800 1000 Hz alternating tone the chime and the ability to silence the horn while allowing the to continue flashing incorporating the control module as shown in the wiring page 2 the control module will control power to horns to produce synchronized operation When using strobes or horn strobes in parallel mode synchro may also be attained without using a control mod if the fire alarm control panel is capable of providing power with a minimum power off time of 10 mS and maximum power off time of 20 mS and with a repetition of 1 second see figure 2 page 2 In parallel mode horn cannot be silenced while maintaining strobe op Option to silence the horn while strobes continue to flash Synchronize horn and strobe using only two wires Operates GOS cid 147 Z cid 148 horn strobe Easy to install INFORMATION Module is rated for 3 Amps at 24 VDC Synchronizes to 1 Hz flash rate Dimensions 3.321 84.3534 mm high x 2.896 mm wide x 1.190 30.2260 mm deep document is not intended to be used for installation purposes We try to keep our information up to date and accurate We cannot cover all specific applications or all requirements All specifications are subject to change without notice For information contact Fire cid 149 Lite Phone 203 484 7161 FAX 203 484 7118 Clintonville Road Northford Connecticut 06472 and Manufacturing System Certified to Standard ISO 9001 in the U S A cid 151 Page 1 of 2 DIAGRAMS NOTE Do NOT loop wires under terminals Use in and out wiring method FIGURE 1 For INDEPENDENT Z Series strobes and horn FIGURE 2 For synchronized temporal horn ONLY PARALLEL horn strobe operation 1 2 ON JUMPERS using the AVS44 control module J5 and on the GOS must be in the top position jumpers are in the top position when from the factory DIAGRAM AT RIGHT 3 2 of 2 cid 151 DF 51933