Fire-Lite MS-5024 Frame & Post

MS 5024 Control Communicator Operating Instructions Only the green AC POWER LED is on All other are off The key to open the panel can be found at this AUDIBLE DEVICES ARE SOUNDING an Alarm Evacuate the protected area Notify the monitoring service and or the Fire Department Tell them briefly what happened and what current status is If the Fire Department is responding be prepared to provide to arriving firefighters Trouble Only Notify the monitoring service and or Fire Department if this is connected to either one and tell them what is Silence audible devices by unlocking and opening the panel pressing the SILENCE key The yellow TROUBLE will remain on Contact authorized service personnel Refer to Local Service Representative block return to normal after an alarm Do not enter the protected area until safe to do so Clear all initiating devices Smoke detectors will not reset if is still smoke in the area Reset the control panel press the RESET key Silencing Alarm signaling circuits may be silenced pressing the SILENCE key The SILENCE LED will turn on alarms will reactivate circuits Press the RESET to clear the silenced condition Alarm silencing may be disallowed for 1 minute if see manual failure or brownout AC POWER LED will go out for fail or brownout and the TROUBLE LED will come on The panel sounder and TROUBLE LED will turn on for either and any other audible trouble devices will sound authorized service personnel immediately Refer to Service Representative block below not allow trouble conditions to remain in the system Protection that the offers has been compromised or when a trouble condition exists and mount adjacent to the control panel Zone n Loss Appliance Circuit 1 Fault Appliance Circuit 2 Fault n Disabled fault Fault Zone n Battery Battery Phone Line Voltage Low Phone Line Voltage Low Number Communications Fault Number Communications Fault Reset Alarm Zone n n n A E n b b 1 2 1 2 clear alarm indications in panel after of alarm has been corrected press turn off the local panel sounder and notification appliance circuits perform a fire drill press 3 ENTER RESET key restores the panel to test the lamps press 5 to the MS 5024 Technical Manual P N for more details Service Representative 50068 Rev A ECN 94 237 9 19 94