System Sensor B110LP Plug-in Detector Base

I AND MAINTENANCE INSTRUCTIONS Plug in Detector Base use with the following smoke detectors US CANADA 1151A 2151A EUROPE 2151E 2151 0 Ratings includes base and detector Min Installing for Proper Use of System Smoke Detectors which detailed information on detector spacing place zoning wiring and special applications Copies of for the Installation of Fire Alarm Systems The detector used with this base must be Description boxes and 4 inch square boxes with or without rings To mount the base remove the decorative separating the ring from the base Use the screws with the junction box to attach the base to the through the appropriate slots in the base see Figure Limitations of Property Protection Smoke Detectors and initi detectors will not work without power AC or DC powered detectors will not sense fires which start where smoke does reach the detectors detector is usually located For this reason there may be large be located on every level and in bedroom within a building detectors have sensing limitations too Ionization detectors general detectors cannot be expected to provide warnings for fires from inadequate fire protection practices violent explosions in high air velocity conditions may have a delay in alarm due to high air velocity environments may create increased dust detectors cannot last forever Limited Warranty alter the obligations or limitations of this Warranty The Company period commencing with the date of manufacture After phoning number send defective units postage prepaid to System Repair Department RA 3825 Ohio Avenue St replace units which are found to be defective because of damage use modifications or alterations occurring after the date manufacture In no case shall the Company be liable for any conse or limitation of incidental or consequential damages so the above or exclusion may not apply to you This Warranty gives you 1 Mounting base to box 2 Wiring diagram for a typical 2 wire detector system ON NOT NOT