System Sensor B112LP Plug-in Detector Base

INSTALLATION AND MAINTENANCE INSTRUCTIONS Plug in Detector Base use with the following smoke detectors US CANADA 1151A 2151A EUROPE 2151E 2151 Ratings includes base and detector Installing for Proper Use of System Smoke Detectors wiring and special applications Copies of this in Canada refer to CAN ULC S524 Standard the Installation of Fire Alarm Systems The detector used with this base must be Description boxes and 4 inch square boxes with or without rings To mount the base remove the decorative separating the ring from the base Use the screws with the junction box to attach the base to the through the appropriate slots in the base see Figure refer to insert for the Limitations of Fire Alarm Systems Limited Warranty alter the obligations or limitations of this Warranty The Company period commencing with the date of manufacture After phoning number send defective units postage prepaid to System Repair Department RA 3825 Ohio Avenue St replace units which are found to be defective because of damage use modifications or alterations occurring after the date manufacture In no case shall the Company be liable for any conse or limitation of incidental or consequential damages so the above or exclusion may not apply to you This Warranty gives you Guidelines to the releasing device manufacturer panels as well as for smoke detectors and their The alarm system cannot be expected to operate if system components have incompatible allow refer to the control panel manufacturer loop resis the System Sensor base and smoke detector being wiring must be installed in compliance with the requirements of the authority having jurisdiction detectors to control panels and accessory devices be color coded to reduce the likelihood of wiring Improper connections can prevent a system from signal wiring the wiring between interconnected ensure that electrical connections are super DO NOT loop wires under terminals 2 3 shorting spring makes it convenient to do this negative out leads so that loop wiring can be tested shorting spring in the base will disengage automati when the detector head is removed from the base 1 Mounting base to box ON NOT NOT Feature DO NOT use the tamper resistance feature if the detector base can be made tamper resistant so the a small screwdriver into the notch as indicated in