System Sensor B116LP Plug-in Detector Base

I AND MAINTENANCE INSTRUCTIONS Plug in Detector Base use with the following smoke detectors US Canada Europe 2151 2151A 2151E Ratings includes base and detector Installing for Proper Use of System Smoke Detectors which detailed information on detector spacing place zoning wiring and special applications Copies of installation in Canada please refer to CAN4 S524 for the Installation of Fire Alarm Systems and The detector used with this base must be Description model B116LP plug in detector base is used with Sensor model 1151 1151A and 1151E ionization heads and model 2151 2151A and 2151E photo refer to insert for the Limitations of Fire Alarm Systems Limited Warranty alter the obligations or limitations of this Warranty The Company period commencing with the date of manufacture After phoning number send defective units postage prepaid to System Repair Department RA 3825 Ohio Avenue St replace units which are found to be defective because of damage use modifications or alterations occurring after the date manufacture In no case shall the Company be liable for any conse or limitation of incidental or consequential damages so the above or exclusion may not apply to you This Warranty gives you 1 Mounting base to box 2 Typical wiring diagram B116LP base is intended for use in 2 wire systems detector base mounts directly to 3 1 2 inch and inch octagon boxes and 4 inch square boxes with or plaster rings To mount remove decorative ring the screws supplied with the junction box and the mounting slots in the base Place decorative Guidelines wiring must be installed in compliance with the signal wiring the wiring between inter connected detectors and alarm system control panels have for allowable loop resistance Consult the panel manufacturer specifications for the total resistance allowed for the particular model control installations where normal ambient temperatures Instructions the clamping plate and tightening the clamping ON NOT NOT screw Use the strip gauges molded into the inside Sensor smoke detectors and mounting bases are with a compatibility identifier located as the last zone wiring of the detector base should be checked the detector heads are installed in them To make jumper After a detector base is properly wired and connection shorts the positive in and positive out