XAL-53 Explosion Proof Pull Station

July 8 1998 Pull Station Conventional Initiating Devices Fire Ring fire alarm stations are suitable for Hazardous areas due to the presence of flammable or vapors combustible dusts or easily ignit fibers or flyings Installation at petroleum refineries chemical and pet plants storage areas and other process facilities where hazardous substances are and stored Areas where emergency control of fire alarm or sig circuits is required Enclosure is made of copper free aluminum alloy Conduit openings are 3 4 19.05 mm NPT feed Red textured powder epoxy paint finish is standard box and cover and provides high visibility for alarm Universal 1 normally open and 1 normally closed furnished standard Bilingual nameplates included per CSA requirement Internal ground screw is standard Wiring range is 12 AWG through 24 AWG solid stranded alarm station is activated by lifting the front cover pulling down ring This quick easy to use two process prevents unintentional operation Op is reset by depressing shaft and returning plate original position AREA Class I Divison 1 and 2 Group C and D Class II Division 1 and 2 Group E F and G Class III Hazardous Locations NEMA 7CD 9EFG BLOCK is a trademark Hubbell document is not intended to be used for installation purposes We try to keep our information up to date and accurate We cannot cover all specific applications or all requirements All specifications are subject to change without notice For information contact Fire cid 149 Lite Phone 203 484 7161 FAX 203 484 7118 Clintonville Road Northford Connecticut 06472 and Manufacturing System Certified to Standard ISO 9001 in the U S A cid 151 Page 1 of 2 ARRANGEMENT ACTIVATED DATA enclosure is made of cast copper free aluminum al It is suitable for Class I Groups C and D Class II E F and G and Class III hazardous locations All must comply with applicable local and or Na Electrical Code installation DO NOT use looped wire under ter Break wire run to provide supervision of con all electromechanical devices these control stations occasional maintenance Parts may wear out or defective due to adverse environmental conditions Maintenance Data below DATA this device from the supplying circuit be removing the cover To prevent corrosion lubricant should be occasionally as follows Killark cid 147 LUBG cid 148 lubricant to box cover flanges Dow Corning Molykote 33 Grease light consistency to shaft Keep all flanges clean and free of scratches Some internal service parts are available Consult the factory for parts breakdowns 2 of 2 cid 151 DF 51861