Gamewell-FCI 600 Series, SAN, SAN-RC Serial Annunciator Drive

600 Series Series Series Series SAN RC SAN RC SAN RC SAN RC Annunciator Driver 600 Series Serial Annunciator Driver SAN is used to a lamp or an LED in an annunciator It also provides a positive output per point used for the interface building automation systems or driving relays Each is capable of interpreting the instructions from the CPU initiating its own programmed response and the instructions to the next device Gamewell FCI 600 Systems can accommodate up to devices connected to the serial communications port In to the serial annunciator drives SAN these include a remote annunciator RAN2 and a printer interface RPI This combination of devices the Gamewell FCI status control network Since device contains its own microprocessor each device be programmed independently A series of devices can programmed directly over the network from a single saving valuable installation time Programming is via Windows configuration software SAN input point can activate up to five output points matrix annunciation There are two basic models avail the SAN and the SAN RC The SAN 16 is equipped 16 freely programmable outputs which can be used for control or monitoring expandable to 128 points Point Driver Modules PDM SAN 16 RC includes all of the features of the SAN 16 the ability to read inputs into the system The SAN 16 has provisions for the following four inputs Acknowledge Silence Test addition to the basic 16 outputs there are the following 8 common outputs System Alarm System Trouble required LED used for System Power used for a local Silence is a registered trademark of Underwriters Laboratories Inc Windows is a registered trademark of Microsoft Corporation SAN RC per ANSI UL 864 9th Edition to 64 devices supported on a single 600 Series panel Windows field programming Dual optically isolated serial ports with building automation systems standard ASCII communication Microprocessor based in 16 point increments to 128 points remote system control Mounting track ISO 9000 2000 Company APPROVED are for information only are not intended for installation purposes and are subject to change without notice No responsibility is assumed by Gamewell FCI for their use Honeywell International Inc All rights reserved Rev B page 1 of 2 Clintonville Road Northford CT 06472 1610 USA Tel 203 484 7161 Fax 203 484 7118 Information annunciator driver module main with 16 outputs Serial annunciator driver with four remote inputs eight 8 common outputs 16 outputs driver module for field expanding annunciator drivers 16 outputs 26 66 cm field expansion to con between rows of PDM 16 mounted GW69999 track 16 40.64 cm for SAN field expan holds four 4 PDM 16 serial interface module mounts 600 Series control 632 654 and 658 to RS 232 ouputs This model is not required for use the IF602 and IF610 Systems cable Programmed via a SAN RAN program on the Gamewell FCI website This program is only available to authorized distributors Continued status control network including SAN units is con to the main 600 Series control panel via an RS 232 communication line The SIM 232 module is used to an isolated RS 232 output from the main CPU of IF632 IF654 and IF658 FACPs The IF602 and IF610 contain built in RS 232 ports SAN units provide a means for remote annunciation control of the system via a simple RS 232 connection driver units fit neatly into an annunciator unit and be used to drive the LED or incandescent lights of a or graphic type annunciator When it is necessary remote system control the SAN 16 RC provides for up eight inputs for system control Any or all inputs may be to customize any given command station capabili SAN units can also be used to interface with other systems via ASCII or used where dry contacts or a output is required The SAN outputs can be to drive a relay to interface or control virtually any point or group of points Specifications annunciation and control for the main control panel be supplied where indicated Remote annunciation control shall be accomplished via the RS 232 data line It shall be possible to add up to 64 to the communication line Each device shall be of driving up to 128 points It shall be possible to annunciators printers and LCD alphanumeric displays a single line without the need for special software shall not be placement sensitive All devices shall individually field programmable and independent from other The device shall be identified by Gamewell FCI numbers Annunciator Basic SAN and SAN RC provide drives VDC Power Current 0.04 A max Current Power A max A max per output W x 4 H x 2 D W x 10.2 H x 5.1 D cm Point Drive Module Power Current 0.002 A A Current the SAN Module Rev B page 2 of 2 Clintonville Road Northford CT 06472 1610 USA Tel 203 484 7161 Fax 203 484 7118