Gamewell-FCI AMM-2F Addressable Monitor Module

Addressable Devices Monitor Module Gamewell FCI Velociti Series addressable monitor module AMM 2F is a single B Class B initiating device circuit IDC with a 47KW end of line resistor This provides an address for any device or group of devices connected to this on the signaling line circuit SLC of the Gamewell FCI addressable series fire control panel Any initiating device with normally open N O dry contacts may made addressable when connected to the AMM 2F module Velociti Seriems use a communication protocol that substantially increases the of communication between the sensors and certain Gamewell FCI analog fire alarm controls These devices operate in a grouped fashion If one of devices in the group has a status change the panel microprocessor stops the poll and concentrates on the single device The net effect is response speed up five times greater than earlier designs AMM 2F module can be programmed to provide a wide variety of input functions the Gamewell FCI addressable series fire alarm control panels It can be identified a manual station heat detector plenum detector waterflow switch tamper switch contact smoke detector projected beam smoke detector sub loop remote zone It can also serve as a remote system silence system reset system acknowledge or switch It is even possible to customize its device type to meet specific job initiating device circuit of the AMM 2F can support a maximum line resistance of to 40 ohms allowing the use of linear heat detection devices The compact size the installation of the module inside manual stations or mounting boxes of types of alarm initiating devices Information Addressable monitor module single circuit Style B Class B BENEFITS Compact size allows installation Class B Style B circuit 40 Ohm line resistance Connects to any each initiating circuit open dry device Technical Specifications Current 000375 amps Current 00060 amps Temperature 32 to 120 F 0 to 49 C Humidity 10 to 93 non condensing Resistance 47K ohms 1.3 L x 2.5 W x 0.5 D 3.3 x 6.4 x 1.3 cm AND HUMIDITY RANGES system meets NFPA requirements for operation at 0 49 120 and at a relative humidity 93 2 noncondensing at 32 2 90 3 the useful life of the system s standby batteries the electronic components may be adversely affected extreme temperature ranges and humidity Therefore is recommended that this system and its peripherals be in an environment with a normal room of 15 27 80 E3 Series Control Panel is designed to comply with following standard Standard UL 864 9th Edition LISTINGS AND APPROVALS listings and approvals apply to the modules in this document In some cases certain or applications may not be listed by certain agencies or listing may be in process factory for latest listing status S1949 3023594 FDNY 227 03 E VOL IV 7300 1703 0102 9001 Certification a complete listing of all approvals and please visit and Gamewell FCI registered trademarks of International Inc is a registered trademark Underwriters Laboratories document is not intended be used for installation We try to keep our information up to and accurate We cannot all specific applications anticipate all requirements specifications are subject to without notice more information more about Gamewell FCI AMM 2F and other products by visiting www Gamewell FCI com Gamewell FCI Clintonville Road CT 06472 1610 F 11 17 Honeywell International Inc