Gamewell-FCI AMM-4F Addressable Monitor Module

Addressable Devices Series AMM 4F Monitor Module Gamewell FCI Velociti Series addressable monitor module AMM 4F features a Style D Class A initiating device circuit It may also be configured as a Style B B initiating circuit with end of line resistor This module provides an address for device or group of devices connected to this circuit Any alarm initiating devices normally open N O dry contacts such as heat detectors linear heat detection 4 wire projected beam smoke detectors 4 wire smoke detectors water flow tamper switches manual stations etc may be installed in this circuit Velociti Series use a communication protocol that substantially increases the of communication between the sensors and certain Gamewell FCI analog fire alarm controls These devices operate in a grouped fashion If one of devices in the group has a status change the panel microprocessor stops the poll and concentrates on the single device The net effect is response speed up five times greater than earlier designs AMM 4F module is designed for installation in the signaling line circuit of any analog addressable control panel The initiating circuit of the AMM 4F a maximum line resistance of 40 ohms allowing the module to accommodate a of initiating devices at a distance from the module The AMM 4F is designed mount in a 4 square junction box 2 1 8 deep initiating device circuit of the AMM 4F can support a maximum line resistance of to 40 ohms allowing the use of linear heat detection devices Information Addressable monitor module single circuit Style D Class A or Style BC A B BENEFITS Compact size allows Offers a visual rotary Accommodates any dry contact device installation Includes Class A Style or Class B Style B circuit switch 01 159 Provides a 40 ohm line for each device circuit Bi color LEDs flash whenever the is addressed light steady red on Only the red LED operative in panels that not operate in Velociti Series AMM 4F Technical Specifications Current 000375 amps LED flashing Current 005 amps LED lit Temperature 32 to 120 F 0 to 49 C Humidity 10 to 93 non condensing resistor 47K ohms 4 1 2 H x 4 W x 1 1 4 D 11.4 x 10.2 x 3.2 cm AND HUMIDITY RANGES system meets NFPA requirements for operation at 0 49 120 and at a relative humidity 93 2 noncondensing at 32 2 90 3 the useful life of the system s standby batteries the electronic components may be adversely affected extreme temperature ranges and humidity Therefore is recommended that this system and its peripherals be in an environment with a normal room of 15 27 80 Velociti Series AMM 4F is designed to comply with following standard Standard UL 864 9th Edition LISTINGS AND APPROVALS listings and approvals apply to the modules in this document In some cases certain or applications may not be listed by certain agencies or listing may be in process Consult for latest listing status S1949 3023594 FDNY 277 03 E Vol VI 7300 1703 0102 9001 Certification a complete listing of all approvals and please visit E3 Series and are trademarks of International document is not intended be used for installation We try to keep our information up to and accurate We cannot all specific applications anticipate all requirements specifications are subject to without notice more information more about Gamewell FCI Velociti Series AMM 4F and products available by visiting www Gamewell FCI com Gamewell FCI Clintonville Road CT 06472 1610 F 11 17 Honeywell International Inc