Gamewell-FCI ANU-48 Remote LED Driver Unit

ANU 48 LED Driver Module ANU 48 is a remote annunciator used the E3 Series Fire Mass Notification Evacuation and S3 Series Systems Gamewell FCI ANU 48 LED Driver is a remote annunciator that is used in with the following systems E3 Series Expandable Emergency System Trouble System Silenced Power Fault output is also provided for the following Alarm Supervisory NAC 1 Silenced NAC 2 Silenced Underwriters Laboratories only address testing at ambient down to 32 F the ANU 48 is Mutual Approved for an ambient of 40 F C non condensing the ANU 48 is powered externally each circuit provides a maximum of 050 amp a maximum of 2.4 amperes per each module you install more than four ANU 48 modules external regulated and Class 2 power power supply Listed for use with the protective signaling units is required INFORMATION ANU 48 Remote LED Driver System E3 Series Combined Fire and Mass System E3 Series Broadband Voice Evacuation S3 Series Small Addressable Fire Alarm Panel provides output for up to eight remote panel and 48 remote LEDs contributing to versatility and flexibility of the Gamewell System switches may be programmed to operate any of the following predefined functions Speaker Circuit Switch Fire Fighter Phone Switch Auxiliary Control Switch using a bank of two use one switch for each On Off function addition the switches may be programmed operate with the following custom defined System Silence Alarm Acknowledge Lamp Test Alarm Tone On Drill and System Reset LED AND BENEFITS Trouble Acknowledge Manual Select Listed under UL Standard 864 10th Edition Listed under UL Standard UL2572 2nd for Mass Notification Includes input for eight software switches maintained on contact Provides output for up to 48 remote LEDs or circuits The INI VG Series ILI MB E3 ILI95 MB E3 SLP Smart Loop Panel can support up to ANU 48 LED driver modules or ASM 16 modules for a total of 128 switches 768 LEDs Installed up to 3,000 feet 914.4 m from the panel and up to 15 additional can be connected Adaptable to be mounted in any remotely UL Listed annunciator enclosure with the ANU 48 TECHNICAL SPECIFICATIONS Voltage 24 VDC resettable Current 0.011 amp Temperature 32 to 120 F to 49 C Humidity 0 to 93 at 90 F 32 C Add 003 amp for any LED to be lit for any when powered When externally each driver circuit provides a of 0.050 amp with a maximum of 2.4 per ANU 48 sub assembly 48 circuits AND HUMIDITY RANGES system meets NFPA requirements for at 0 49 120 and at a humidity 93 2 RH noncondensing 32 2 90 3 However the useful of the system s standby batteries and the components may be adversely by extreme temperature ranges and Therefore it is recommended that this and its peripherals be installed in an with a normal room temperature of 27 80 ANU 48 is designed to comply with the standards Standards UL 864 10th Edition UL 2572 2nd Edition for Mass Notification LISTINGS AND APPROVALS listings and approvals apply to the specified in this document In some certain modules or applications may not listed by certain approval agencies or listing be in process Consult the factory for the listing status Listed S1869 UL 864 10th Edition UL 2572 2nd Edition for Mass Notification Approved 3017416 FDNY COA 6077 7165 1703 0125 of Chicago Approved 1 Class 2 High Rise of Denver Approved 9001 Certification Series and Gamewell FCI are trademarks of Honeywell Inc is a registered trademark of Laboratories Inc document is not intended to be for installation purposes We to keep our product information and accurate We cannot all specific applications or all requirements All are subject to change notice of origin U S A Gamewell FCI Clintonville Road CT 06472 1610 M 06 20 Honeywell International Inc