Gamewell-FCI B200S-LF Low Frequency Sounder Base

Addressable Devices Series B200S LF 520 Hz Low Frequency Sounder Base Gamewell FCI B200S LF sounder base sets a new standard for performance and aesthetics The B200S LF low frequency sounder base is designed to with the NFPA 72 sleeping space requirement to produce a fundamental of 520 Hz 10 with a square wave or its equivalent Studies show that lower frequency centered around 520 Hz is the ideal frequency to awaken sleeping even those occupants with mild to severe hearing loss The B200S LF only the Velociti protocol In addition the B200S LF offers maximum in installation configuration and operation to comply or exceed the UL 268 and 464 requirements sounder base in to the communication between the sensor head and the alarm control panel to use the same address as the detector but uses a unique type on the loop The FACP can then use that same address to command an sounder or a group of sounders to activate You can set the command from panel so that it is set to the specific event allowing the selection of volume tone or custom tone patterns sounder base offers the following installation features Pre wired mounting plate fits various junction box sizes The housing locks to a mounting plate with two retaining screws to prevent tamper Information Low Frequency Intelligent Programmable Sounder Base bright white Ivory Low Frequency Intelligent Programmable Sounder Base ivory 1 The B200S LF WH and B200S LF IV produce a fundamental frequency of 520 Hz 10 with a square wave or its equivalent The are designed to comply with the NFPA 72 sleeping space requirement 2 The B200S LF WH and B200S LF IV sounder bases are compatible with the E3 Series S3 Series or GWF 7075 fire alarm control BENEFITS Offers a programming Programs the Complies with UL 464 for 520 low frequency Complies with UL 268 Provides 520 Hz square wave tone Produces multiple tone Offers a mechanical feature that the removal of attached sensor Built in supervision no relays required Supports Continuous Temporal 3 ANSI 4 and March tones to control and the sounder independently Broadcasts over two levels 75 or Includes a pre wire plate that various junction sizes for flexibility When the B200S LF is to the NAC it can be with System Sensor devices Uses a mechanical feature that the removal of attached sensor Employs coded that may be over the and promptly Series B200S LF Technical Specifications Velociti Series B200S LF is designed to comply with following standards Standards UL 268 UL 464 LISTINGS AND APPROVALS listings and approvals apply to the modules in this document In some cases certain or applications may not be listed by certain agencies or listing may be in process factory for latest listing status S1911 7300 1653 0238 9001 Certification a complete listing of all approvals and please visit Series and Velociti Series registered trademarks and S3 Series is a trademark Honeywell International inc is a registered trademark Underwriters Laboratories document is not intended be used for installation We try to keep our information up to and accurate We cannot all specific applications anticipate all requirements specifications are subject to without notice Specifications Diameter 6.875 1 2 17.46 cm Height 2.0 5.08 cm less sensor Weight 0.50 lb 227 gm Temperature Range For the applicable Operating Temperature Range refer to the Base Cross Reference Chart at www systemsensor com Humidity Range 10 to 93 relative non condensing Specifications Supply Voltage 16 to 33 VDC VFWR Standby Current 500 uA maximum Current High Volume Setting 70 mA max 33.0 VDC 90 mA max 24.0 VDC 140 mA max 16.0 VDC Low Volume Setting 15 mA max 33.0 VDC 20 mA max 24.0 VDC 25 mA max 16.0 VDC Operating Voltage 15 to 32 VDC Standby Current 300 uA maximum base only Output High Volume Greater than 85 dBA minimum measured in a UL reverberant room at 10 ft 24 Volts in continuous tone Low Volume Greater than 75 dBA minimum measured in a UL reverberant room at 10 ft 24 Volts in continuous tone AND HUMIDITY RANGES system meets NFPA requirements for operation at 0 49 120 and at a relative humidity 93 2 noncondensing at 32 2 90 3 the useful life of the system s standby batteries the electronic components may be adversely affected extreme temperature ranges and humidity Therefore is recommended that this system and its peripherals be in an environment with a normal room of 15 27 80 more information more about Gamewell FCI Velociti Series B200S LF other products available by visiting www Gamewell FCI com Gamewell FCI Clintonville Road CT 06472 1610 D 04 18 Honeywell International Inc